Search:

Tag: feedrate

Search: Search took 0.00 seconds.

  1. Standard gear configuration for Hercus 9" and 260 lathes

    Started by allterrain50, 28th June 2014 01:58 PM
    260, achieve, attached, basic, bright, cutting, depending, enable, excluding, feedrate, feedrates, finish, gear, geometry, hercus, lathes, mal, model, models, numerous, occasions, photo, set, setup, speed, spindle, standard, thread, tip, tool, user 7 Attachment(s)
    • Replies: 6
    • Views: 4,565
    Last Post: 22nd October 2014 11:59 AM
    by allterrain50  Go to last post

    Forum:
    THE HERCUS AREA

  2. Dovetail Cutter

    Started by Oldneweng, 1st June 2014 12:08 PM
    2 Pages •
    1 2
    40mm, amount, buying, carbon, ctc, cutter, cutting, cxa, dean, diameter, dovetail, expensive, feed, feedrate, guessing, hss, intend, lathe, low, machining, offer, proposition, qctp, rate, restricted, size, slots, stainless, steel, useable 15 Attachment(s)
    • Replies: 27
    • Views: 4,330
    Last Post: 9th June 2014 10:14 AM
    by Oldneweng  Go to last post

    Forum:
    METALWORK FORUM

Results 1 to 2 of 2