Search:

Tag: compliant

Search: Search took 0.00 seconds.

    • Replies: 0
    • Views: 2,249
    Last Post: 21st May 2013 03:10 PM
    by Reno RSS Feed  Go to last post
  1. Are you sitting comfortably..??

    Started by Reno RSS Feed, 5th April 2013 08:10 PM
    #10, 90mm, access, bca, bit, building, certificate, compliant, concrete, construction, council, f10, fixings, footplates, frame, frames, front, handyman, haphazard, hex-head, plans, posts, provisions, screws, slab, spaced, spacing, stand, steel, thread
    • Replies: 0
    • Views: 1,716
    Last Post: 5th April 2013 08:10 PM
    by Reno RSS Feed  Go to last post
  2. Cavity Sliding Doors Replacement

    Started by ubeaut, 16th November 2008 07:21 AM
    50s, art, broken, cavity, compliant, deco, design/effect, door, doors, glass, hall, house, lounge, matching, modern, options, original, pair, repairing, replace, replacement, second-hand, similar, situation, sliding, sort
    • Replies: 0
    • Views: 2,635
    Last Post: 16th November 2008 07:21 AM
    by ubeaut  Go to last post
  3. What would you do?

    Started by nev25, 15th April 2008 01:33 AM
    arrived, bathroom, charge, circuit, compliant, days, don’t, happened, home, hour, hours, installed, installer, i’m, i’ve, job, kitchen, means, money, original, oven, owner, post, power, question, regulations, replied, run, thread, told
    • Replies: 14
    • Views: 2,787
    Last Post: 17th April 2008 11:41 PM
    by RETIRED  Go to last post
  4. Repairing/replacing Bakelite Switches

    Started by amase, 29th January 2008 06:11 AM
    1940s, advise, anastasia, art, bakelite, changed, compliant, conform, cover, house, inside, investment, lovely, mechanism, property, pushy, renovating, repairing or replacing, repairing/replacing, replace, replaced, rewired, rubber, safety, source, standards, stove, switches, told, wiring
    • Replies: 14
    • Views: 5,297
    Last Post: 2nd February 2008 09:38 AM
    by dan76  Go to last post
    • Replies: 0
    • Views: 1,711
    Last Post: 13th November 2007 10:24 PM
    by Mick Nash  Go to last post

    Forum:
    EMPLOYMENT

Results 1 to 6 of 10