Search:

Tag: 10ee

Search: Search took 0.00 seconds.

  1. shim stock or gauge plate supplier

    Started by .RC., 2nd March 2014 08:51 PM
    2 Pages •
    1 2
    0.95mm, 10ee, 145, 185, 1mm, build, centre, flat, gauge, height, ideas, piece, plate, shim, steel, stock, supplier, tailstock, thereabouts, thick 2 Attachment(s)
    • Replies: 24
    • Views: 4,362
    Last Post: 12th March 2014 05:46 PM
    by .RC.  Go to last post

    Forum:
    METALWORK FORUM

  2. Hardinge DV-59 second operations lathe

    Started by .RC., 6th October 2013 08:41 PM
    2 Pages •
    1 2
    10ee, 1960, bed, belt, belts, chuck, comparing, dv-59, dv59, faceplate, fit, hardinge, headstock, hercus, lathe, loose, low, motor, operations, original, pulley, reverse, section, serial, slide, speed, speeds, spindle, top, variable 5 Attachment(s)
    • Replies: 15
    • Views: 3,488
    Last Post: 10th October 2013 09:05 PM
    by Steamwhisperer  Go to last post

    Forum:
    METALWORK FORUM

  3. Painting machines

    Started by .RC., 7th May 2013 09:32 PM
    13 Pages •
    1 2 3 4 5 6 7 8 9 10 ... 13
    10ee, assistance, bog, casting, defects, enamal, experience, fill, final, gaps, helpful, hints, lathe, machine, machines, pack, paint, painting, polyurethane, primers, products, properly, requires, smooth, sort, special, suitable, tools, type, usual 50 Attachment(s)
    • Replies: 187
    • Views: 19,970
    Last Post: 17th September 2013 12:33 AM
    by Hornetb  Go to last post

    Forum:
    METALWORK FORUM

  4. Monarch 10EE in Melbourne

    Started by .RC., 18th October 2008 09:11 AM
    000, 10ee, 1942, accurate, brand, complicated/expensive, condition, disclaimer, drive, ebay, electrics, equal, including, interestingly, lathes, located, machine, machines, manual, melbourne, modern, monarch, offer, rebuild, rebuilding, service, sydney, us$50, wrong
    • Replies: 13
    • Views: 5,039
    Last Post: 9th November 2008 10:52 PM
    by hux  Go to last post

    Forum:
    METALWORK FORUM

  5. Tool pr0n

    Started by Fossil, 11th December 2007 01:55 PM
    0-4000rpm, 10ee, absolute, dream, dreaming, found, lathe, machine, monarch, morning, owning, post, pr0n, shot, tool, toolroom
    • Replies: 8
    • Views: 1,906
    Last Post: 12th December 2007 10:35 PM
    by hux  Go to last post

    Forum:
    METALWORK FORUM

Results 1 to 5 of 5