Results 1 to 5 of 5
  1. #1
    Join Date
    Jan 2007
    Location
    Sydney
    Posts
    86

    Default Advice on deck structure around a spa please.

    Hi

    I'm after a bit of advice on how to create the deck support structure around a spa if anyone has any suggestions please.
    See the attached pic for details.
    The spa will sit on the ground, with the top sitting just above the deck level. (ie the deck will not have to support the spa.)
    The spa does however sit right where a beam would have run the length of the deck.

    How can I support the joists around the cutout for the spa?
    Can I run a "mini beam" between the full length joists on either side of the spa and use that to support the shortened joists? I have drawn these in my attached pic.
    Do I need to put in extra posts? One near each corner of the spa?
    All relevant dimensions are on the pic. Spa is approx 2m square. Height above ground level at that end of the deck is approx 1.2m.

    Many thanks!

  2. #2
    Join Date
    Jul 2007
    Location
    Bathurst
    Posts
    7

    Default

    I did a similar thing around my kids sunken sand pit.

    However i used the "I have no idea" approach and just put timber all the way around the lip of the sandpit so the ends of the boards were sitting on something. Then I put like your "mini beam" between the two outside joists.

    The kids haven't fallen to their deaths yet!

    However, my joists were over engineered by about 100% so the two outside joists have no trouble taking the wobble out of the cut one.
    Isn't it ironic that nature gave the tortoise a drag factor of 0.3

  3. #3
    Join Date
    Oct 2006
    Location
    Tallahassee FL USA
    Age
    82
    Posts
    0

    Default

    I suggest putting a post at the outboard end of each of the joists running next to the spa, similar to the pattern you've shown on the middle beam. This will reduce weird flexural behaviour of the deck. Might be best to double the joists alongside the spa, generously nailed together, or at least bolted together near the mini-beam's attachments.

    The short joists spanning from the ledger to the mini-beam, and from the outboard beam and the other mini-beam can be stopped at the mini-beams. Put the mini-beams as close to the spa as possible. Use the same depth timbers for all of these components, using joist hangers for attachments. The way you've shown would have the mini-beams suspended from the joists alongside the spa; that will work too.

    Verify your timber sizes for your spans and loads. Building code and/or one of the local brethren can advise on Oz requirements.

    Joe
    Of course truth is stranger than fiction.
    Fiction has to make sense. - Mark Twain

  4. #4
    Join Date
    Jun 2007
    Location
    In a House
    Posts
    256

    Default

    Mate I saw an episode on back yard blitz once where they had the sunken spa tub thing in the deck an gee it looked like alot of work I think you can get onto their website still for some pointers

    Scotty cam is the man

  5. #5
    Yonnee's Avatar
    Yonnee is offline Trailer Bloke & Mild Mannered Moderator
    Join Date
    May 2007
    Location
    Tooradin, Vic.
    Age
    52
    Posts
    484

    Default

    I would do just as you're thinking with a short bearer running either side of the spa.

    I would be careful as to the spacings you're running of the bearers & stumps, because of bounce.
    Also, when I was doing mine, my builder mate advised me to either put the bearers on top of the stumps, or make a small check-out at the top of the stump that the bearer can sit on so that you're not relying on just the bolt to support the entire deck. Imagine the dramas if the bolt gives way with a few people on the deck and the stump punches through the deck floor.
    Too many projects, so little time, even less money!
    Are you a registered member? Why not? click here to register. It's free and only takes 37 seconds! Doing work around the home? Wander over to our sister site, Renovate Forum, for all your renovation queries.

Similar Threads

  1. Split level deck with spa and pergola
    By BustedThumbs in forum DECKING
    Replies: 35
    Last Post: 6th January 2008, 09:18 PM
  2. Advice on low lying deck
    By groovemachine in forum DECKING
    Replies: 0
    Last Post: 26th February 2007, 12:42 PM
  3. Pool Deck Advice
    By mcchaddy in forum POOLS, SPA & WATER FEATURES
    Replies: 1
    Last Post: 30th January 2007, 12:53 PM
  4. Deck refinishing
    By jimj in forum FINISHING
    Replies: 2
    Last Post: 20th April 2005, 07:33 AM
  5. Advice: Secret nailing of deck boards
    By yugenpillay in forum DECKING
    Replies: 3
    Last Post: 12th April 2005, 09:03 AM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •