Results 1 to 9 of 9
Thread: Hi All
-
21st September 2021, 11:45 AM #1
Intermediate Member
- Join Date
- Sep 2021
- Location
- Newcastle
- Posts
- 1
Hi All
Finally after enough procrastination I have got myself a wood lathe. Picked up an old Toolmac N3570. Has not had much use so good to get started on. Just looking at getting some Vicmarc stuff, chuck, etc. The lathe I bought does not have a manual, would anyone know where I could get one.
-
21st September 2021, 01:14 PM #2
GOLD MEMBER
- Join Date
- May 2013
- Location
- Rockhampton QLD
- Age
- 69
- Posts
- 1,570
Welcome to the forum Joe.
Ross
-
21st September 2021, 05:27 PM #3
Life's Good, Enjoy each new day & try to encourage
- Join Date
- Dec 2009
- Location
- Faulconbridge, Lower Blue Mountains
- Age
- 68
- Posts
- 2,576
G'Day & Welcome to a top forum "Joe".....
There are quite a good few members around Hunter region and cross NSW plus the rest of the country.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork......
Cheers crowie
PS - On your lathe question, may I suggest you start a new thread in the woodturning section as you'll get a bigger audience and thus more potential answers....
-
22nd September 2021, 06:37 PM #4
Bulnesia Arborea
- Join Date
- Jun 2018
- Location
- Melbourne
- Posts
- 471
Welcome Joe
-
23rd September 2021, 08:45 PM #5
SENIOR MEMBER
- Join Date
- Jul 2004
- Location
- Adelaide
- Age
- 77
- Posts
- 425
Welcome to the forum.
Regards
Keith
-
24th September 2021, 08:44 AM #6
Senior Member
- Join Date
- Aug 2014
- Location
- Geelong, Victoria
- Posts
- 38
Try posting in the woodturning forum and include the model of the lathe in the title. Many of the long-term members only follow the forums of interest to them and others scan the new posts and read the titles that grab their attention.
Have you tried searching for the manual?
Bruce
-
24th September 2021, 01:11 PM #7
GOLD MEMBER
- Join Date
- Jun 2005
- Location
- Townsville. Tropical Nth Qld.
- Posts
- 0
Hi Joe, welcome mate.
Rgds,
Crocy.
-
30th September 2021, 05:48 AM #8
GOLD MEMBER
- Join Date
- May 2011
- Location
- FRANCE
- Age
- 59
- Posts
- 1,892
Welcome to the forum
-
5th October 2021, 07:20 PM #9
On a journey
- Join Date
- Oct 2008
- Location
- Leopold, Victoria
- Age
- 66
- Posts
- 1
Welcome JoeW1964 and I hope you enjoy your turning adventure. When looking for info on the Toolmac N3570 it comes up with a metal lathe or a Thicknesser, so not having any luck for you.
Dallas
Reply With Quote
Bookmarks