Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Cutting Ingots down to size
-
17th April 2021, 07:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,458
Cutting Ingots down to size
I bought 7kg of Bronze (3% silicone) recently. It arrived as a single ingot. It's far too large to fit any of my crucibles, so I need to cut it somehow. It's too thick to saw by hand. My only other cutting tools are a Dremel (too small) and an angle grinder (which I've never used). Do you think I would be able to cut it with the grinder? The ingot is quite thick and I'm concerned about being able to cut deep enough, safely, and minimising waste.
What are the usual methods of cutting ingots? I'm having a hard time finding any information about this. I don't have the money to go out and buy an expensive machine that would have no use to me beyond this one purpose, but I'm open to other solutions.
Read the full thread at metalworkforums.com...
Similar Threads
-
Cutting down door size
By Reno RSS Feed in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 17th September 2012, 05:20 PM