![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 8 of 8
Thread: Side board mirror top recovery
-
17th August 2019, 11:49 AM #1
SENIOR MEMBER
- Join Date
- Jan 2007
- Location
- Brisbane
- Posts
- 186
Side board mirror top recovery
Hi,
I'm starting the cleaning of this unit top reseal and use again. I'm looking for advice on cleaning the pressed metal ready for sealing again. Also would appreciate any information on what the symbols on it mean.
Thanks for the help.
#1 whole unit
#2 Pressed metal
#3 Bevelled mirror corner (missed pieces)
#4 Wood face
Complete.jpgPressed metal.jpgMirror edge.jpgFascia.jpg
-
17th August 2019, 04:08 PM #2
Woodworking mechanic
- Join Date
- Jan 2014
- Location
- Sydney Upper North Shore
- Posts
- 710
Is the pressed metal steel or brass?
-
17th August 2019, 08:42 PM #3
SENIOR MEMBER
- Join Date
- Jan 2007
- Location
- Brisbane
- Posts
- 186
-
17th August 2019, 08:57 PM #4
SENIOR MEMBER
- Join Date
- Jan 2007
- Location
- Brisbane
- Posts
- 186
Cleaning of wood and mirror has started
Complete with sanding started.jpgShelf sanding started.jpgMirror edge frame sanding started.jpgFascia sanding started.jpg
-
17th August 2019, 09:33 PM #5
The symbols just mean its Art Nouveau styleing
art nouveau symbols - Google Search
Yeah Ive seen thin copper over steel . It rubs off easy . If its rusted through I'm pretty sure you can only try and see how good you can make it look.
Rob
-
22nd August 2019, 08:47 PM #6
SENIOR MEMBER
- Join Date
- Jan 2007
- Location
- Brisbane
- Posts
- 186
Progressing with gentle dismantling and cleaning. Even found the mirror makers mark.
IMG_8680.jpg IMG_8687.jpg IMG_8690.jpg IMG_8692.jpgIMG_8691.jpg
-
7th September 2019, 08:51 AM #7
SENIOR MEMBER
- Join Date
- Jan 2007
- Location
- Brisbane
- Posts
- 186
Slow but there is progress. I have taken scrap pine and been cutting down very thin strips to secure the panels and mirror.
Side panels reinstalled.jpgIMG_8872.jpgIMG_8873.jpg
-
7th September 2019, 09:31 AM #8
SENIOR MEMBER
- Join Date
- Jan 2007
- Location
- Brisbane
- Posts
- 186
Cleaned first by scraping and then some sanding. Sealing with Danish oil. Panels going back in ready to have cover at back installed. While the mirror is in this is where it will stop while I work on how to handle the loss of some silver. I never meant this as a master piece so don't think I can justify a lot of money on a new silvering. I will also need to decide what to put on the bottom and how to hang in a bathroom.
Renwal.jpgPanel renewed.jpgPanel renewed 002.jpgPress metal renewed 002.jpgPress metal renewed.jpg