Results 1 to 4 of 4
Thread: T & G Flooring
-
10th May 2005, 05:39 PM #1
New Member
- Join Date
- Apr 2005
- Location
- Greta NSW 2334
- Posts
- 4
T & G Flooring
I am in the process of laying our hardwood floor over yellow tongue particle board and I'm reading here on the forum problems with boards being too tight etc. I'm not clamping the boards before nailing, just tapping them in snug. Would that be ok, or should I leave a small gap line between the boards. I've never done this before so any advice would be gladly received.
Thanks, Ben
-
10th May 2005, 05:50 PM #2
SENIOR MEMBER
- Join Date
- Feb 2003
- Location
- Garvoc VIC AUSTRALIA
- Posts
- 3,208
If the himudity is high pull them up tight.
If its dry leave them a little loose.
-
11th May 2005, 09:13 AM #3
New Member
- Join Date
- Apr 2005
- Location
- Greta NSW 2334
- Posts
- 4
Thanks Bob, I was a bit worried, I'll do as you suggest
Regards, Ben
-
11th May 2005, 09:47 AM #4
Hwd Flooring Manufacturer
- Join Date
- Jun 2004
- Location
- Grafton, N.S.W.
- Age
- 64
- Posts
- 546
Ben.
Go to the Timber Queensland website and download their flooring installation fact sheet.
Google "timber queensland"
Hooroo.
Regards, Trevor
Grafton
Reply With Quote
Bookmarks