![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 2 of 2
-
18th May 2012, 11:41 AM #1
New Member
- Join Date
- May 2012
- Location
- australia
- Posts
- 1
Flashing for an old sash window in a weatherboard
Could anyone help me with some pictures of the correct placement of flashing for an old sash window frame that is being put into a 1910 weatherboard?
It is a sash window from a brick house and will be installed from the inside. There is no plaster on the wall on the inside and the weatherboards can be taken off as I need to put sarking up too at some point.
I was intending on using aluminium (as I have plenty) and I am particularly interested in how the flashing is cut and overlapped correctly and where in relation to the architraves it is.
Could anyone also make recommendations on gaps around the window? I have seen some referenced to leaving 10mm under the sill to allow drainage.
The only way I think it can be fixed to the frame is top and bottom as the weights are running down the sides.
Thanks for any help ...
-
20th May 2012, 06:07 PM #2
GOLD MEMBER
- Join Date
- Aug 2011
- Location
- bilpin
- Posts
- 510
Lets start from the bottom of your question and work up. The window must be fixed through the sides, weights or no weights. The reason for this is any nails through top and sill would puncture the flashing.
There is the method called "beaded in" where the frame has an outer and inner architrave or moulding that holds the window in position. As for clearance around the window, the top is the most important 10-12mm to allow for frame settlement. The sides only require enough clearance to allow for flashing up turns at each end and are packed back to the frame where the holding nails are located. The sill is raised only enough to allow the flasing to drain to the outside. The sill flashing extends the full width of the window and turns up against the studs which are notched with a saw cut, angled down towards the ouside, into which the ends of the flashing are tucked. The internal edge of the flashing is turned up to finish just below the top edge of the architrave. The outer edge turns down over the external cladding.
Top flashing runs behind first line of cladding and sarking if present, on face of studs/head then lips over the front edge of the top of the window frame. The ends run past each side of the window at least 100mm with the bottom edge of these extensions trimmed up to the bottom of the weather board.
Hope this helps.
Similar Threads
-
Flashing for weatherboard house windows
By Reno RSS Feed in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 9th September 2010, 11:20 PM -
Window flashing
By Crabtree-ites in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 30th July 2006, 06:04 PM -
Window flashing?
By neddy in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 12Last Post: 31st January 2006, 09:56 PM