![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 5 of 5
-
29th March 2011, 07:54 PM #1scubabob Guest
critters living in old gramophone
i have been offered a rather old gramophone which is missing a few bits, including a foot and some fretwork but that's neither her nor there. Thing is though there are tiny little holes all over one leg which no doubt are the same little critters that took up residence in my house many years ago. Cabot's "Bar-D-K" took care of the residentual ones but i was wondering if i use that to dispose of them in the gramophone, would it have any effect on the finish after i fix it up?
-
30th March 2011, 10:01 AM #2
Good question. I can only suggest trying it all out on a scrap piece of timber first to see what happens. Another idea is to apply a seal coat of shellac (eg UBeauts White Shellac) before applying further finish.
cheers
WendyBox Challenge 2011 - Check out the amazing Boxes!
Twist One - Wooden Hinge/Latch/Catch/Handle
Twist Two - Found Object
Twist Three - Anything Goes
-
30th March 2011, 09:22 PM #3scubabob Guest
cheers
-
30th March 2011, 09:59 PM #4
.
- Join Date
- Jul 2005
- Location
- Victoria
- Posts
- 0
-
31st March 2011, 08:06 PM #5scubabob Guest
Will do Lignum. I believe it is a "Salonola" but i am not 100% sure, it is still living at the other persons house until i can house it without the critters taking up residence in my place. I have researched it previously (I'm a bit of an historic buff ) and am currently researching what timbers and varnishes they used. I will keep you posted.
Similar Threads
-
Old Clock & Gramophone
By woodsprite in forum GENERAL ODDS N SODSReplies: 5Last Post: 2nd October 2006, 01:34 PM -
Living will
By normell in forum JOKESReplies: 0Last Post: 22nd November 2005, 09:44 AM
Members who have read this thread: 0
There are no members to list at the moment.