![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 5 of 5
Thread: How did they do this?
-
2nd October 2010, 03:38 AM #1
Novice
- Join Date
- Dec 2008
- Location
- Perth
- Posts
- 0
How did they do this?
Hi all,
I have the task of making an honour board to match an existing item as per photos.
The existing item is made from 18mm MDF/Jarrah veneer, and I can make and route a panel to match without issue, except for the edge.
Does anyone have any clues as to how this edge finish was produced? In the past I have sprayed a jarrah stain onto MDF edges , sanded and recoated and this has produced a good finish, but the whole board has a darker edge. It appears that this particular item has had some type of stain brushed (?) onto the routed edge and then coated. I am at a bit of a loss on how to replicate it.
Any ideas?
-
2nd October 2010, 07:41 AM #2
Looks like solid timber edge to me. What's it look like on the back?
-
2nd October 2010, 09:03 AM #3
Hey Allsport,
Like Barraboy said, I would be gluing on a solid edge strip, and then doing the router job.
HazzaBLast edited by HazzaB; 2nd October 2010 at 09:06 AM. Reason: spelling and punctuation repais
It's Hard to Kick Goals, When the Ba^$%##ds Keep moving the Goal Posts.
Check out my Website www.harrybutlerdesigns.com.au
-
2nd October 2010, 10:11 AM #4
Senior Member
- Join Date
- Nov 2008
- Location
- Mackay, Queensland
- Posts
- 23
the face and the edge are diffrent grain pattens. look at the back of the display, im with the rest - edge banding has been used
-
3rd October 2010, 06:41 PM #5
Definitely an edge strip and you can probably buy it in the length pre moulded from any decent timber shop maybe even Bunnies.