Hello All,

Just like m6sports thread I too am removing a load bearing wall to open up our kitchen area and was hoping for some advice with regards to temporary supporting the three areas of the roof that the struts are supporting while I remove them to put the beam in place.
I was thinking along the lines of acro props from the floor, through ceiling to the underneath of the under-purlins to provide support while struts are removed, beam put in place and then struts re-installed onto beam.
Any feedback appreciated or further suggestions/advice.

Pics below show where the beam is going and how much wall will be removed below.

Attached Thumbnails



Read the full thread at RenovateForum.com...