![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
-
18th May 2012, 10:00 PM #1
Flashing for an old sash window in a weatherboard
Could anyone help me with some pictures of the correct placement of flashing for an old sash window frame that is being put into a 1910 weatherboard?
It is a sash window from a brick house and will be installed from the inside. There is no plaster on the wall on the inside and the weatherboards can be taken off as I need to put sarking up too at some point.
I was intending on using aluminium (as I have plenty) and I am particularly interested in how the flashing is cut and overlapped correctly and where in relation to the architraves it is.
Could anyone also make recommendations on gaps around the window? I have seen some referenced to leaving 10mm under the sill to allow drainage.
The only way I think it can be fixed to the frame is top and bottom as the weights are running down the sides.
Thanks for any help ...
Read and reply to the full thread at RenovateForum.com....
Similar Threads
-
Flashing for an old sash window in a weatherboard
By col320ce in forum FINISHINGReplies: 1Last Post: 20th May 2012, 06:07 PM -
Flashing for weatherboard house windows
By Reno RSS Feed in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 9th September 2010, 11:20 PM -
Window flashing
By Crabtree-ites in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 30th July 2006, 06:04 PM -
Window flashing?
By neddy in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 12Last Post: 31st January 2006, 09:56 PM