Out of Square Makita LS1212 SCMS

I was getting a little unhappy that I had forked out a fortune for a Makita Saw and I couldn't even get the blade square to the fence. I attempted to adjust the fence several times but always reached the limit of adjustment.

So last night I adjusted the the saw angle until it was spot on then locked that position. The problem was that the O degree quick lock didn't engage at this point. So I loosened the screws on the alloy bar underneath that held the lock bar in place and the lock bar amazingly just clicked into position. I tightened the screws and problem fixed!!!:D

G'Day Mat,
I'm not quite sure.
Are you unhappy with the Mac;
OR
Pleased with yourself?

If you don't want it.................



Ivan in Oz

I'm happy with it now - not so happy when the cuts were not square. If I was happy to accept out of square cuts I would have bought a saw at half the cost!

Thanks for the great advice! I haven't been using the stops because they were out. I just used the degree marker on the side. You're fix worked like a charm.