T & G Flooring

Printable View

10th May 2005, 05:39 PM
Ben Jackson

T & G Flooring

I am in the process of laying our hardwood floor over yellow tongue particle board and I'm reading here on the forum problems with boards being too tight etc. I'm not clamping the boards before nailing, just tapping them in snug. Would that be ok, or should I leave a small gap line between the boards. I've never done this before so any advice would be gladly received.
Thanks, Ben
10th May 2005, 05:50 PM
echnidna

If the himudity is high pull them up tight.
If its dry leave them a little loose.
11th May 2005, 09:13 AM
Ben Jackson

Thanks Bob, I was a bit worried, I'll do as you suggest

Regards, Ben
11th May 2005, 09:47 AM
glock40sw

Ben.

Go to the Timber Queensland website and download their flooring installation fact sheet.

Google "timber queensland"

Hooroo.
Regards, Trevor
Grafton

All times are GMT +11. The time now is 06:15 AM.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.