Search:

Tag: regulator

Search: Search took 0.00 seconds.

  1. Are old compressors worth rescuing?

    Started by rogerwilco, 15th June 2021 11:15 PM
    • Replies: 13
    • Views: 4,873
    Last Post: 23rd June 2021 03:00 PM
    by AndrewOC  Go to last post
  2. gun regulator

    Started by sussertown, 29th December 2017 02:21 AM
    acetone, blurry, clean, damage, damaged, entire, feel, gun, husky, lacquer, lens, regulator, rough, smudge, spray
    • Replies: 7
    • Views: 9,927
    Last Post: 8th January 2018 12:22 PM
    by onetrack  Go to last post
  3. Adjusting air compressor for spraying

    Started by Arron, 7th September 2012 08:04 AM
    adjust, adjusting, affected, air, arron, bar, cheers, compressor, cool, drops, finish, gun, hard, harder, head, holding, leaving, lot, motor, noticing, outlet, pressure, refills, regulator, restart, spraying, stream, tank, true, weakens
    • Replies: 14
    • Views: 2,365
    Last Post: 15th September 2012 11:11 AM
    by soundman  Go to last post

    Forum:
    FINISHING

  4. Setting up my gun for spraying

    Started by Arron, 2nd August 2012 06:49 PM
    actual, afraid, air, amount, arron, bar, bit, cheers, compressor, gun, hvlp, idle, lacquer, manual, matter, operating, pressure, pulled, questions, regulator, run, screw, set, setting, simply, spraying, stylwood, supposed, trigger, wattyl
    • Replies: 2
    • Views: 1,209
    Last Post: 2nd August 2012 07:32 PM
    by Arron  Go to last post

    Forum:
    FINISHING

  5. Hvlp gun or airbrush

    Started by eisbaer, 6th April 2012 10:20 PM
    airbrush, applying, bar, bought, compressor, decide, finally, fine, finer, gun, hvlp, lacquer, line, naive, overkill, pressure, pump, pushes, question, regulate, regulation, regulator, setup, spray, sprayed, spraying, stick, suspect, told, type
    • Replies: 2
    • Views: 2,065
    Last Post: 8th April 2012 10:19 PM
    by eisbaer  Go to last post

    Forum:
    FINISHING

  6. hvlp pressure settings

    Started by carlow, 4th March 2011 11:26 PM
    ?also, ?or, carlo, finally, hvlp, info, nozzle, oil, position, pressure, regulator, setting, settings, size, spraying, staring, system, trap, varnish, viscosity, water
    • Replies: 2
    • Views: 2,046
    Last Post: 12th March 2011 09:53 PM
    by carlow  Go to last post

    Forum:
    FINISHING

  7. 6 Volt Solar Battery Charger

    Started by Reno RSS Feed, 14th October 2009 12:10 PM
    1.5, automatic, batteries, battery, bit, charged, charger, combination, drive, fing, gates, install, panel, plan, proving, re-chargeable, read, receiver, regulator, renovateforum.com, runs, solar, step-down, suggestions, thread, transformer, tricky, volt, volts
    • Replies: 0
    • Views: 1,695
    Last Post: 14th October 2009 12:10 PM
    by Reno RSS Feed  Go to last post
  8. Setting Up HVLP gun

    Started by Pete F, 11th July 2009 04:06 PM
    abuse, air, awaiting, bottom, carbothane, coming, finish, fixed, gun, happy, hvlp, ibe, incidentally, install, laying, oil, posting, pressure, psi, pull, reg/oiler, regulator, set, setting, setup, spray, swinging, type, unused, volume
    • Replies: 0
    • Views: 1,415
    Last Post: 11th July 2009 04:06 PM
    by Pete F  Go to last post

    Forum:
    FINISHING

  9. Electrical Work what can Can I Do unlicensed

    Started by ubeaut, 16th November 2008 07:10 AM
    act, cabinet, carry, chief, class, conversation, definition, division, document, electrical, electricity, equipment, esv, illegal, insurance, job, live, means, office, pay, person, powerpoint, recently, regulator, rules, safety, screw, unlicensed, victoria, workers
    • Replies: 0
    • Views: 4,279
    Last Post: 16th November 2008 07:10 AM
    by ubeaut  Go to last post
  10. 12vdc to 6vdc Constant Voltage Regulator

    Started by Stringy, 11th May 2008 05:42 PM
    12v, 12vdc, 50s, 6vdc, australia, boat, built, car, constant, converting, electrical, forum, gauges, ignition, keeping, late, luck, mallory, rebuilding, regulator, run, ski, starter, system, timber, told, vintage, voltage
    • Replies: 13
    • Views: 5,609
    Last Post: 12th May 2008 07:30 PM
    by DavidG  Go to last post
  11. Plumbing Help Needed - Gas Tape

    Started by damien, 22nd March 2008 04:52 PM
    2 Pages
    1 2
    advice/help, apparent, bit, bunching, connections, develop, forced, gas, grooves, issue, joins, joint, leak, needed, perfect, pipe, plumbing, properly, regulator, screwing, sealing, slipping, soap, stop, stove, tape, thread, unscrew, water, yellow
    • Replies: 27
    • Views: 5,220
    Last Post: 31st March 2008 10:20 PM
    by damien  Go to last post

    Forum:
    PLUMBING

  12. "crocodile" finish

    Started by astrid, 29th November 2007 02:41 PM
    $120, 2-3, astrid, belgium, bucks, clock, crocodile, finish, heat, intend, paid, patches, patina, refinish, regulator, separated, shellac, suggest, vienese
    • Replies: 8
    • Views: 1,971
    Last Post: 2nd December 2007 10:41 PM
    by durwood  Go to last post

    Forum:
    FINISHING

  13. Gas regulators

    Started by Pulpo, 22nd November 2007 11:39 AM
    $120, barbie, change, cost, gas, home, labour, lpg, mentioned, plumber, pulpo, regulator, regulators, stage, twin
    • Replies: 6
    • Views: 2,521
    Last Post: 29th November 2007 03:54 PM
    by Pulpo  Go to last post
  14. Gas Cooktop regulator?

    Started by Spelunx, 8th February 2007 07:46 PM
    bottle, bottled, brand, burners, cheers, cooktop, four-burner, gas, house, jayson, low, regulator, roughly, snuff, sort, typical
    • Replies: 5
    • Views: 4,467
    Last Post: 12th February 2007 07:10 PM
    by Spelunx  Go to last post

    Forum:
    KITCHENS

  15. Westernhouse gas oven no longer working

    Started by Com_VC, 30th October 2006 08:51 PM
    blocked, bright, coming, cooktop, electric, fine, gas, idea, ideas, ignition, light, line, longer, match, orange, oven, quick, recently, regulator, stopped, westerhouse, westernhouse, working, wrong
    • Replies: 4
    • Views: 2,689
    Last Post: 17th November 2006 10:08 PM
    by Superiorgas  Go to last post
  16. BBQ Conversion

    Started by BrisBen, 13th February 2006 02:54 PM
    bbq, bottle, bottled, bucks, burner, burners, cheers, connect, conversion, converting, covered, experience, gas, gasfitter, hey, inside, mill, oven, people, pipe, regulator, requirements, run, special, supplies, town
    • Replies: 14
    • Views: 8,915
    Last Post: 13th July 2006 04:05 PM
    by D-I-Yer  Go to last post
    • Replies: 5
    • Views: 17,920
    Last Post: 5th July 2006 07:41 PM
    by weezlebub  Go to last post
  17. Regulator for LPG gas cooktop??

    Started by Pulpo, 27th January 2006 05:38 PM
    50mm, arrow, assume, bolt, brass, comfirm, cooktop, dreadful, flows, gas, instructions, lpg, nut, pulpo, purchased, purpose, regulator, screw, screw/small, sticking, told, [regulator], [simpson]
    • Replies: 8
    • Views: 8,156
    Last Post: 3rd February 2006 10:15 AM
    by The Big O  Go to last post
  18. Help needed connecting an air regulator

    Started by Timber_finisher, 23rd November 2005 12:28 PM
    air, angle, ash, attachment15863, bottom, brass, casting, centre, clarithane, connecting, connects, headed, hex, hole, hoping, mountain, needed, pack, plug, polyester, polyurethane, pressure, regulator, screwed, shaft, spray, table/bench, topcoat, tops, wattyl
    • Replies: 8
    • Views: 2,095
    Last Post: 25th November 2005 09:40 AM
    by MurrayD99  Go to last post

    Forum:
    FINISHING

  19. Spray Equipment - Confused

    Started by Island Nomad, 29th September 2005 06:04 PM
    130mls, 1mm, bit, cable, compressor, confused, cup, equipment, filters, gravity, gun, guns, guys, hvlp, hvpl, mini, moisture, nozzle, porter, regulator, run, s-106t/j12g, s770, spray, star, suggest, suggestions, threads, touchup, traps
    • Replies: 14
    • Views: 3,182
    Last Post: 3rd October 2005 09:26 AM
    by Harry72  Go to last post

    Forum:
    FINISHING

  20. air compressor regulator question

    Started by violincrafter, 26th March 2005 04:39 PM
    45-50, air, assist, assume, coming, compressor, difference, experts, explained, flow, forward, gauge, guages, gun, hope, max, obstruction, overlooking, photos, pressure, psi, question, reducing, regulator, set, spray, understanding, usage, valve, violincrafter
    • Replies: 10
    • Views: 3,766
    Last Post: 3rd June 2005 10:06 PM
    by Studley 2436  Go to last post

    Forum:
    FINISHING

  21. Spluttering Spray Gun

    Started by silentC, 28th June 2004 01:02 PM
    2 Pages
    1 2
    40l, 60psi, add, air, built-in, cheapo, compressor, constant, coverage, finish, fluid, gun, ideas, outlet, patchy, pick-up, pressure, proper, regulated, regulator, results, set, splutter, spluttering, spray, starts, steady, thinners, type, venturi
    • Replies: 23
    • Views: 6,348
    Last Post: 5th August 2004 10:19 PM
    by Kris.Parker1  Go to last post

    Forum:
    FINISHING

  22. spray guns - whats good and whats not!!

    Started by Rowan, 2nd January 2004 06:47 PM
    $69, 2.5hp, 40lt, advice, ball, buying, compressor, feed, flat, good, gravity, gun, guns, hvlp, idea, o-rings, park, prices, realise, regulator, running, set, setup, sort, spray, straight, sux, system, systems, times
    • Replies: 14
    • Views: 12,775
    Last Post: 17th January 2004 07:22 AM
    by Rowan  Go to last post

    Forum:
    FINISHING

Results 1 to 23 of 25