Search:

Tag: likelihood

Search: Search took 0.00 seconds.

  1. Milling old jetty timbers

    Started by comgreserv, 21st October 2008 04:28 AM
    2 Pages •
    1 2
    30mm, 4hrs, advice, anticipation, appears, badly, boards, circumference, coming, cut, effects, fella, finishing, firewood, hazardous, home, hope, jetty, likelihood, loading, logs, mill, milling, penetrates, residiual, timber, timbers, truck, washed, water
    • Replies: 15
    • Views: 7,375
    Last Post: 26th October 2022 04:41 PM
    by GraemeCook  Go to last post

    Forum:
    SMALL TIMBER MILLING

  2. The likelihood of burls being ok from rotten tree

    Started by RedShirtGuy, 1st December 2014 12:09 AM
    burls, likelihood, rotten, tree
    • Replies: 2
    • Views: 1,192
    Last Post: 1st December 2014 07:58 PM
    by RedShirtGuy  Go to last post

    Forum:
    TIMBER

  3. Timber sealing (ends) - an observation which leads to a question...

    Started by FenceFurniture, 30th May 2014 11:16 PM
    board, check, checked, coat, cut, cuts, drying, ends, enlighten, exposure, fibre, grain, half, inside, lead, leads, likelihood, moisture, movement, observation, outwards, paint, question, rough, sealing, smooth, soak, thin, timber, unsealed
    • Replies: 13
    • Views: 3,477
    Last Post: 22nd September 2014 01:45 AM
    by FenceFurniture  Go to last post

    Forum:
    TIMBER

  4. Effects of Radiation on Scot's Pine Near Chernobyl

    Started by Scott, 10th August 2013 11:44 AM
    1986, abnormal, accident, april, bbc, cell, chernobyl, chernobyls, effects, exposure, forms, genetic, growth, impact, legacy, likelihood, nuclear, pine, radiation, reactor, recorded, scot, scots, shown, south, story, tasmania, tree, trees, west
    • Replies: 1
    • Views: 1,427
    Last Post: 10th August 2013 10:22 PM
    by bsrlee  Go to last post

    Forum:
    TIMBER

  5. Is this Lyctus Borer damage?

    Started by Fuzzie, 28th November 2012 06:01 PM
    active, affected, attack, borer, cosmetics, damage, dry, form, heavily, indeterminate, jig, likelihood, lyctus, matter, obvious, piece, reason, rot, sapwood, size, species, squish, straight, suitable, tablesaw, timber, timber?242595, touch, understand, weathered 1 Attachment(s)
    • Replies: 1
    • Views: 1,705
    Last Post: 28th November 2012 06:39 PM
    by Rod Gilbert  Go to last post

    Forum:
    WOODWORK - GENERAL

  6. Clear coat dissolving stain

    Started by RussellB, 15th August 2010 12:23 AM
    action, apply, bit, brush, clear, coat, deeper, dissolving, finish, fix, hair, hand, increases, light, likelihood, patches, patchy, pressed, remove, requiring, result, smoothly, smudge, stain, sticky, surface, thicker, touched, touches, wide
    • Replies: 4
    • Views: 2,714
    Last Post: 18th August 2010 02:28 PM
    by RussellB  Go to last post

    Forum:
    FINISHING

  7. Converting Under the house...

    Started by Reno RSS Feed, 13th August 2010 03:30 AM
    1800-1900mm, 1950-1960, 200-300mm, appreciated, bad, bottom, cheerio, concrete, converting, dead, dig, fall, floor, greatly, happening, house, joists, junk, likelihood, odd, prefer, pretty, question, read, renovateforum.com, scorch, space, stumps, suggestions, thread
    • Replies: 0
    • Views: 1,427
    Last Post: 13th August 2010 03:30 AM
    by Reno RSS Feed  Go to last post

    Forum:
    STRUCTURAL RENOVATION, ROOFING, DEMOLITION, etc

Results 1 to 7 of 8