Search:

Tag: shims

Search: Search took 0.00 seconds.

  1. Shims to fix old chair

    Started by JPDM, 29th October 2013 10:25 AM
    • Replies: 1
    • Views: 1,381
    Last Post: 29th October 2013 03:50 PM
    by HOOKED.UP  Go to last post

    Forum:
    RESTORATION

  2. shims/packers for door frames

    Started by Reno RSS Feed, 18th September 2013 01:00 AM
    advise, americans, balance, base, bunnings, buy, cabinets, call, cms, couple, door, frames, installing, jimmy, kitchen, level, mitre, pieces, read, renovateforum.com, reply, sell, shims, shims/packers, spirit, sydney, tapered, thin, thread, wood
    • Replies: 0
    • Views: 1,703
    Last Post: 18th September 2013 01:00 AM
    by Reno RSS Feed  Go to last post
  3. stumping a transportable

    Started by Reno RSS Feed, 18th September 2012 01:30 AM
    10m, 550mm, 600mm, accomodation, appreciatedu, approx, cost, deep, diameter, due, exact, footings, height, house, ideas, level, plastic, raise, read, renovateforum.com, sets, shims, steel, stumping, stumps, temporary, thread, transportable, underneath, welded
    • Replies: 0
    • Views: 1,202
    Last Post: 18th September 2012 01:30 AM
    by Reno RSS Feed  Go to last post
  4. French Doors - Hanging

    Started by GMC, 23rd December 2007 10:08 AM
    add, assembly, bit, board, closing, cover, deck, depending, doog, door, doors, drill, fit, frame, french, gap, hanging, header, jamb, jambs, kit, locks, sharp, shims, sill, square, studs, timber, tolerance, width
    • Replies: 3
    • Views: 4,546
    Last Post: 2nd February 2008 03:31 PM
    by GMC  Go to last post
  5. cutting shims

    Started by Ian Wells, 17th October 2007 05:19 PM
    200+, adjustable, cut, cutting, door, doors=, earlier, finger, hard, house, jambs, masonite, nibbler, orange, packing, risks, rock, safe, shims, solution, spear, tablesaw, tacking, tapered, thrower, tired, triton, warped, worth, wrong
    • Replies: 9
    • Views: 3,763
    Last Post: 18th October 2007 04:12 PM
    by scooter  Go to last post
  6. Acceptable slope in a deck

    Started by russall, 19th August 2007 01:13 PM
    acceptable, bearers, buddy, centre, cheers, deck, decking, disgared, foot, hard, house, leant, leave, lucky, medical, meters, nail, nails, painful, posts, reduce, remember, rusted, shims, sit, slope, steel, sticking, visit, yesterday
    • Replies: 2
    • Views: 2,487
    Last Post: 21st August 2007 11:06 AM
    by russall  Go to last post

    Forum:
    DECKING

  7. Door keeps closing

    Started by Tiger, 10th August 2007 05:43 PM
    accord, assess, attached, bit, bottom, cardboard, causing, closes, closing, door, fair, fix, front, helped, hinge, jamb, level, lot, move, planing, removed, shims, shut, thick, top
    • Replies: 8
    • Views: 4,152
    Last Post: 15th August 2007 11:04 PM
    by barn  Go to last post
  8. load bearing or not?

    Started by angrymime666, 6th June 2007 09:35 AM
    actual, added, background, bearing, brick, building, due, excuse, flat, folks, header, load, mold, moveable, newbiness, parrallel, rafters, replace, roof, rot, runs, sets, shims, siding, storey, studded, touch, vinyl, wall, wood
    • Replies: 8
    • Views: 2,145
    Last Post: 11th June 2007 11:57 PM
    by angrymime666  Go to last post
  9. Gap between skirting board and floorboards

    Started by DavidC, 19th January 2005 10:15 PM
    15mm, 5-9mm, bit, board, bowee, confused, covering, cypress, easiest, floor, floorboards, gap, gaps, house, joists, lifted, liquid, mouilding, moulding, nail, nailed, nails, quad, question, real, recorrecting, shims, skirting, split, timber
    • Replies: 5
    • Views: 10,316
    Last Post: 1st February 2005 02:41 PM
    by seriph1  Go to last post

    Forum:
    FLOORING

  10. House Guttering, slope, sealing

    Started by JohnR, 10th September 2004 02:54 PM
    100, add, advice, brought, builder, concealed, experience, friend, guttering, gutters, hatches, house, improve, johnr, joints, marine, rafters, replace, seal, sealing, search, shave, shims, sikaflex, slope, stainless, steel, talks, terms, types
    • Replies: 14
    • Views: 4,112
    Last Post: 13th September 2004 07:50 PM
    by Sturdee  Go to last post
Results 1 to 10 of 13