Results 1 to 4 of 4
  1. #1
    govarney's Avatar
    govarney is offline Novice but getting bettert hrough your help
    Join Date
    Nov 2007
    Location
    Ballarat
    Posts
    0

    Default Ubeaut Sanding Sealer under Wattyl Stylwood (NCL)

    Hello,

    Finishing is not my strong point so after reading the ubeaut data sheet I am not clearer.

    Basically I want to spray Wattyl Stylwood (nitro cellulose lacquer) as a finish. I believe the timber would benefit from a sanding sealer and the only one I have is the ubeaut sanding sealer.

    Does anyone know if I can use this sealer under Stylwood
    Regards,
    G.O.Varvey

  2. #2
    Join Date
    May 1999
    Location
    Grovedale (Geelong) Victoria
    Age
    75
    Posts
    9,665

    Default

    You can use it under pretty much anything.....


    • One coat wiped on with a rag and left for a few hours (preferably over night) to dry.
    • When dry sand very lightly with 800 or 1200 grit abrasive, just enough to get rid of the nibs of torn grain raised up by the sanding sealer.


    That's just about the whole story in a nutshell. You can now finish the surface with whatever you like. You can even get a water dye to soak into the grain after using it.

    Hope this helps.

    Cheers - Neil

  3. #3
    Join Date
    Jun 2007
    Location
    North Of The Boarder
    Age
    68
    Posts
    0

    Default

    Thanks Neil.

    Normally I just spray a light coat of lacquer sand and then top coats.

  4. #4
    govarney's Avatar
    govarney is offline Novice but getting bettert hrough your help
    Join Date
    Nov 2007
    Location
    Ballarat
    Posts
    0

    Default

    Thanks Neil.
    Regards,
    G.O.Varvey

Similar Threads

  1. Thinning wattyl Stylwood
    By Arron in forum FINISHING
    Replies: 6
    Last Post: 16th April 2012, 07:09 PM
  2. ubeaut traditional wax over wattyl stain?
    By metalnwood in forum FINISHING
    Replies: 2
    Last Post: 18th October 2011, 11:47 AM
  3. Sanding Sealer or Grain Sealer
    By Strungout in forum FINISHING
    Replies: 3
    Last Post: 4th October 2004, 12:03 PM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •