![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 7 of 7
Thread: WOODWORKING QUIZ for 18 Dec 04
-
18th December 2004, 08:55 AM #1
WOODWORKING QUIZ for 18 Dec 04
Good Morning Friends,
Four Easy steps to a smooth - as - glass finish.
Can you figure what they might be?
Respectfully,Ralph Jones Woodworking
London, Ohio
-
18th December 2004, 09:53 AM #2
Deceased
- Join Date
- Jun 2003
- Location
- ...
- Posts
- 1,460
Planing, scraping and sanding and then to get a glass finish go and buy a sheet of glass and glue it on.
Peter.
-
18th December 2004, 10:28 AM #3
-
18th December 2004, 03:51 PM #4
Deceased
- Join Date
- Jun 2003
- Location
- ...
- Posts
- 1,460
Bob,
Raising the grain is only needed if you use a cheap water based finish. Something Ralph would never use.
Peter.
-
18th December 2004, 10:29 PM #5
1) Sand
2) Spray on sanding sealer
3) Denib
4) Spray on two topcoats of lacquer and then a mist coat of thinners
Mick"If you need a machine today and don't buy it,
tomorrow you will have paid for it and not have it."
- Henry Ford 1938
-
18th December 2004, 10:45 PM #6
Good Evening Friends,
To achieve the smooth as glass finish here are the four steps.
1.For tight grained woods such as maple, just sand to 220 and apply your desired finish. For open grained woods make up a slurry of wood putty and spread it diagonally to fill the open pores and grain, then sand when dry to 220 and apply finish.
2.To make polyurethane finish flow smoothly without brush marks, add three table spoons of paint thinner in a quart of high gloss finish. Do not use fast drying poly. Brush on three coats, sanding with 220 grit sand paper between coats.
3. Sand the third coat of finish with 320, 420, and then 600 grit sand paper.Remove the sanding dust. Inspect the surface for flaws by wiping with thinner. Then apply finish.
4.Remove any dust moats with 1500 grit sand paper. Make a pad with a soft cotton rag, and buff the surface to a high sheen with 3M Finesse-it II Finishing Material.
Who in the world said this was EASY?
Thank you for your support.
Respectfully,Ralph Jones Woodworking
London, Ohio
-
18th December 2004, 10:54 PM #7
Ralph,
We do like your quizzes, honest, even when we tease you by giving you silly answers.
I wonder if you've ever visited the home page of this forum?