minimum pitch for corrugated iron roof?

[gurumon]

Evening all,

I have been looking at replacing the roof on the lounge (it's already stuffed which makes me confident i can't do any worse ).... and extending it out as a deck at the same time.

my problem is.... all the web searching on minimum falls and pitches for corrugated iron roofing has left me more confused than when i started. ive seen "standards" from 180mm over 9metres up to a whopping 1metre fall over 9metres.

now it would be great if everyone could go out in the dark and measure their roof pitches for me but i dont think that's going to happen.

can anyone give me a rule of thumb for calculating the minimum fall of a corrugated iron roof?

[Sir Stinkalot]

Alll depends on the profile .... as little as 1°

Try checking bluescope steel website for the profile you want to use and it will give you the minimum pitch.

[macca2]

Have a look at stratco .com.au It will give you minimum falls for any iron roof.

macca

[Sir Stinkalot]

Or here ..... 5° or 1:12.

[gurumon]

or http://www.stratco.com.au/products/r...corrugated.asp


thanks everyone - my web searching skills suck, mystery solved though - general consensus is 1:12 for traditional corrugated iron

[Grunt]

From an aesthetics point of view, I prefer a high pitch roof. If you are trying to sell a house in Brunswick with skillion roof on the back, you will get less money than one with a high pitch roof.

[Barry_White]

Minimum pitch for corrugated is 5 degrees. Trimdek profile goes down to 2 degrees and kliplock will go down to 1 degree.

[gasp]

For corrugated steel roofing where the rafter length can be covered with a single sheet the minimum slope is 1:11 for lapped sheets its 1:8

[Barry_White]

No one uses multiple sheets lengthways on roofs today unless it is over 21 metres which is the maximum length Lysaghts can carry on an extended semi-trailer.

When I worked for Lysaghts for 11 years it was, and still is 1 in 12 for corrugated.

[ozwinner]

If you are trying to sell a house in Brunswick with skillion roof on the back, you will get less money than one with a high pitch roof.

Just as well I dont have one to sell then??

Al :confused:

[DJM]

From various manufacturer's technical specs:

LYSAGHT Trimdeck 2%
LYSAGHT Klip-Lok 1%
STRATCO Pro-Dek 1%
STRATCO Smartspan 2%
METROLL Metlock 1%
METROLL Trimclad 3%
LASERLITE 5%