![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 8 of 8
-
6th July 2023, 08:42 PM #1
Novice
- Join Date
- Jun 2023
- Location
- SE Melbourne
- Posts
- 10
Where to get 4.2m decking board ripped
Hi
Just wondering where could I take a 4.2m decking board ripped say 30mm wide?
I知 not confident to DIY to a good standard.
Sent from my iPhone using Tapatalk
-
6th July 2023, 09:02 PM #2
A good timber yard that still has a sawbench should be able to sort it for you.
Melbourne is a big place, pretty sure you don稚 want suggestions 2 plus hours drive for a 10 minute job.
Updating your location will help for recommendations.
-
8th July 2023, 11:54 PM #3
Novice
- Join Date
- Jun 2023
- Location
- SE Melbourne
- Posts
- 10
Good point.
I知 in the Monash area.
I
Sent from my iPhone using Tapatalk
-
9th July 2023, 09:10 AM #4
A circular saw might work out for you.
Put a pencil line all the way along the board, clamp up the board (on saw horses or something), and go nice and steady. When you need to shift the board just stop pushing the saw and let it spin to a stop and leave it in place. Shift the board along a bit, reclamp, and try to make sure the saw is in the best spot (ie. the blade turns freely) and on the line when switching on again.
So, it doesn't come out perfectly because when did it it wobbled a bit here and there. I cut some decking boards like that once and I was surprised just how well it worked out.
-
9th July 2023, 09:47 AM #5
SENIOR MEMBER
- Join Date
- Sep 2013
- Location
- Jarrahdale WA
- Posts
- 78
Ripping long board
Using the fence that most likely came with your circular saw is a great way to ensure you stay straight. Cut from the side that you want to keep so you can ensure the size is correct. I have been known to add a long strip of straight hardwood to said fence as out of the box they seem too short.
-
13th July 2023, 06:43 PM #6
Member
- Join Date
- Jun 2010
- Location
- SW Victoria
- Posts
- 51
Gotta DIY that mate
Methods as above. Then 5mm round-over bit to finish top edge, to match the opposite edge.
-
17th July 2023, 07:22 PM #7
Novice
- Join Date
- Jun 2023
- Location
- SE Melbourne
- Posts
- 10
-
18th July 2023, 12:21 AM #8
You might be surprised. Take your time. Set it up carefully, get comfortable, don't hold your breath, relax, and don't push yourself. My first came out better than expected and all I was doing was following a line I'd drawn.
Similar Threads
-
Decking, shaping a bowed board
By Afro Boy in forum DECKINGReplies: 10Last Post: 29th October 2006, 05:47 PM