![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
-
22nd August 2012, 06:30 PM #1
Hinges for 2340x1200 entrance door
Hi, I'm installing a 2340x1200 entrance door with hinges.
I can't justify the cost of a pivot door system.
Now, what hinges do you recommend?
I had a quick look on ebay and it seems 100 X 75 X 2.5mm was the way to go.
I plan on putting 4 hinges on the door.
I saw these on ebay:
Door Hinges Stainless Steel 100mm x 75mm x 3mm | eBay
10 Pairs of Door Hinges - Stainless Steel 100 x 75 x 3mm | eBay
The other ones I was looking at, but non-bearing ones are:
New Door Hinge Vinco SS Butt 100x75x1.6mm Fixed Pin SSH1003L-F | eBay
Door Hinges - Architect Brand - Polished Stainless Steel | eBay
Any reasons why I should avoid the ebay ones?
What is the bearing used for? to make the door easier to open?
Also what screws should I use?
Thank you for your advice.
Read and reply to the full thread at RenovateForum.com....
Similar Threads
-
Replacing door knobs (entrance set)
By ubeaut in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 16th November 2008, 07:21 AM -
Exterior entrance door - what finish ?
By gong_wood in forum FINISHINGReplies: 1Last Post: 19th July 2005, 06:21 AM -
Recessed panel entrance door
By gcutting in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 5Last Post: 28th January 2004, 11:47 PM -
Recessed panel entrance door
By gcutting in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 27th January 2004, 09:49 PM