![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 3 of 3
-
5th October 2010, 12:29 PM #1
Novice
- Join Date
- Jan 2010
- Location
- Fremantle
- Posts
- 11
Have YOU used an Infrared Paint Stripper?
I have been looking to use an infrared paint stripper on my skirting boards. I want to strip them back to bare wood, then finish with some kind of clear varnish.
I want to know about your experince of using this new way of stripping wood.
Fremantle - Western Australia
-
5th October 2010, 12:31 PM #2
no sorry, but I have used the hot air guns, very tedious and tiresome but they do a relatively good job!
G'day I'm Dave!
-
8th October 2010, 03:19 PM #3
Senior Member
- Join Date
- Dec 2004
- Location
- Brisbane
- Posts
- 0
I use a fishtail burner (flame) hooked up to the bbq bottle. Very quick. Minor burns not a prob if repainting, or even clear coating.
Good thing about this method it dries the paint well and does not clog sandpaper.
Much cheaper than Infra Red thingy.
When I did my skirting boards I removed them and did them in shed at a nice height. I also use belt sand paper by hand for the hard to get too bits/curves etc.
cheers
conwood
Similar Threads
-
Infrared Paint Stripper (Jarrah)
By Freo in forum FINISHINGReplies: 1Last Post: 4th October 2010, 06:09 PM -
Homemade Paint Stripper
By glenmackinnon in forum PAINTINGReplies: 4Last Post: 5th March 2008, 07:59 PM -
infrared Speedheater paint remover
By jimj in forum PAINTING, PLASTERING, TILING, DECORATING, etc.Replies: 8Last Post: 1st May 2006, 06:53 AM -
Paint Stripper
By Shaty40 in forum FINISHINGReplies: 4Last Post: 30th September 2005, 08:50 AM