Results 1 to 3 of 3
  1. #1
    Join Date
    Apr 2007
    Location
    gold coast
    Posts
    2

    Default What do you suggest

    I'm in the process of putting a patio up next to a pool area.
    To set the area off nicely I thought I'd deck underneath although this will be over stamped concrete and not totally necessary.
    The total area is about 45 m2 so I'm looking to cut costs.
    The idea I had was a nice area near a garden bed where I could just put down a square area about 3.6m X 3.6m and leave the rest concrete.
    On this "raised deck" I was going to put in a built in BBQ maybe surrounded by built in seating area.
    It was going to be rafters just sitting on the concrete with decking nailed on, until I saw this photo. (hopefuuly attached)

    With this I was going to build a "box" of 200mmx50mm X 3.5m and put the "slats inside.
    The question is what size do you reckon the slats should be (and most economical) to buy.
    I see an add in a Bunning Catologue for treated pine decking 90x22 at $2.20/m. Would this be suitable if I riped it in half and then turned on edge??

    I'm only a bush carpenter so any advice is appreciated

  2. #2
    Join Date
    Mar 2007
    Location
    Melbourne
    Posts
    60

    Default

    seems like an awful waste of timber, turning it on its side only covers 45mm at best where as one piece flat covers 90mm.....
    If cost is a factor then use hardwood joists .....200 x 50 treated pine to form the "box", and have each rail 350mm apart for strength .....if you are only a "bush" chippy .....then I would suggest joist hangers on either side would make it easier for you and bolt them into the 200x50mm with coach bolts .....on the opposing side to the joist hangers, cut in a rebate into the 200 x 50, .....depth and width of 20mm so the lip of the decking sits inside (about 20mm).....then you will have something to nail into without then need to support it underneath (saves timber).....I would do a sketch for ya .....but I just downloaded sketchup and I am pretty crappy with it ..LOL...but I think you get my drift ...good luck with it

  3. #3
    Join Date
    Mar 2007
    Location
    sydney
    Posts
    228

    Default

    If you have the stamped conc why not wait til you have the funds to do it right .....Once its done its unlikely you'll come back and make it any better later

    cheeers utemad

Similar Threads

  1. Please suggest a caption.
    By craigb in forum JOKES
    Replies: 27
    Last Post: 21st January 2005, 10:09 AM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •