![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
-
24th August 2009, 11:20 AM #1
Silver soldering vertical pipe join - any trick ?
I'm going to reopen 2 blocked 0.5 inch copper pipes (one cold, one hot water) and join new copper pipe to another wall of my bathroom.
I read many information about how's silver soldering done and I think I'm confident to diy. My question is when you heat up the pipe and start fill join with silver soldering stick, will the solder just run down and not fill the join properly ??
Read the full thread at RenovateForum.com...
Similar Threads
-
is this the right flux for silver soldering copperpipe?
By ubeaut in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 0Last Post: 16th November 2008, 07:10 AM -
Silver soldering 3/4 inch pipe with MAPP gas
By emptybucketman in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 7Last Post: 6th July 2007, 10:56 PM -
How to do reliable silver soldering
By Arron in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 11Last Post: 23rd May 2005, 11:19 AM