Laminated Benchtops

[Larry LP]

G'day; I'm new at this but would like info on whether anyone in Perth knows where I could get laminated benchtops that I have bought cut to size. My problem is that the Kitchen is C shaped so the joins need to be cut to 45 degrees and people are telling me it's not as simple as it looks. Your help with this would be great.

[renomart]

Do you know if your walls are square? What depth are the benchtops. How much are they oversize?

Do you have a plunge router?

[Larry LP]

The kitchen isn't far off being square, I feel the splash back will take care of any discrepencies as all benches have overhead cabinets and I can pack the wall out a bit. The benches are 606mm deep. One bench is 215mm over, I have one that will make up both corners one at 1000mm long the other 800mm from a 1860mm top. The breakfast bar needs 200mm removed but one end butts up against a wall. I can get hold of a plunge router

[renomart]

Righto then, check out this info from my buddies at DGI. It is as simple as it looks. Follow steps 3 and 7. You don't have to biscuit the joints. Silicon mitre joins before tightening bolts. Then stand back and admire your handiwork!

[Larry LP]

Thanks Renomart the information from DGI is what I was looking for. I will be working on the bench tops next weekend so I will let you know how it went. Thanks again