Hi Guys,

I bought some anwing brackets from Mitre-10 and am trying to figure out how to install them. I've bought and installed similar products before but these are a little different.

Instead of running and dying straight into the weatherboards they have a little vertical piece that the angled wood runs into that sticks out (see "A" on the LHS of the attached picture).

I didnt notice this until I got them home...I'm used to brackets as depicted on the RHS of the pictuure that stop at an angle against the weatherboards so you can just run some tin roofing ("B") straight up stopping when it hits the house.

Any ideas how I'm supposed to install these buggers?

Attached Thumbnails



Read and reply to the full thread at RenovateForum.com....