Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: WOODWORKING QUIZ for 8 Dec 04
-
8th December 2004, 10:18 AM #1
SENIOR MEMBER
- Join Date
- Apr 2004
- Location
- London, Ohio
- Age
- 89
- Posts
- 537
WOODWORKING QUIZ for 8 Dec 04
Good Morning Friends,
Running A little late as I had a busy day.
Finding knobs with custom - threaded studs can be a challenge.
How would/do you remedy the situation?
Respectfully,Ralph Jones Woodworking
London, Ohio
-
8th December 2004, 11:09 AM #2
SENIOR MEMBER
- Join Date
- Apr 2003
- Location
- Tolmie - Victoria
- Age
- 68
- Posts
- 2,747
Drill them out and re-tap the threads?
- Wood Borer
-
8th December 2004, 11:31 AM #3
Pretend my avatar moves!
- Join Date
- Nov 2003
- Location
- Australia and France
- Posts
- 5,415
Use touch latches so you don't need knobs.
P
-
8th December 2004, 11:45 AM #4
GOLD MEMBER
- Join Date
- May 2003
- Location
- Kuranda, paradise, North Qld
- Age
- 62
- Posts
- 4,374
Why would you want different thread on them? It's simple enough to go to the local fastener warehouse and get longer/shorter/different finish/material screws/bolts/nuts/widgets. :confused:
Mick"If you need a machine today and don't buy it,
tomorrow you will have paid for it and not have it."
- Henry Ford 1938
-
8th December 2004, 01:17 PM #5
SENIOR MEMBER
- Join Date
- Feb 2003
- Location
- Garvoc VIC AUSTRALIA
- Posts
- 7,769
-
8th December 2004, 06:48 PM #6
Registered
- Join Date
- Aug 2003
- Location
- .
- Posts
- 7,949
Come to my shop, we get knobs in everyday, and I dont mean hardware.
Al
-
8th December 2004, 10:25 PM #7
SENIOR MEMBER
- Join Date
- Apr 2004
- Location
- London, Ohio
- Age
- 89
- Posts
- 537
Good Evening Friends,
Here is an easy way to make your own. Thread a 1/4 - 20 flathead machine screw of sufficient length completely into the knob and mark the threads immediately below the knob with a permanent marker. Back out the thread till you see the mark. Apply 5 minute epoxy to the threads above the mark.
Tighten the epoxied screw into the knob, and wipe off any squeeze out.
Thank you for your support.
Respectfully,Ralph Jones Woodworking
London, Ohio
Reply With Quote
