![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 8 of 8
Thread: G'day from Terrigal
-
15th January 2014, 08:29 PM #1
New Member
- Join Date
- Jan 2014
- Location
- Terrigal
- Posts
- 1
G'day from Terrigal
G'day All,
I am recently retired and looking to broaden my woodworking skills. I have a reasonably equipped workshop and have far more enthusiasm than talent!
I attempted to build my daughter a sun lounge using steam bent 20mm staves of Tassie Oak from plans in a US Magazine.
They suggested using Red or White Oak. While I am aware Tassie Oak isn't Oak, it was the best straight grain timber I could find.
After steaming the first 6, I split 5 and the other is about to split.
The sun lounge turned into a quite respectable coffee table.
I would appreciate any guidance in choosing a timber that I can steam and bend or any other suggestions.
Cheers
Martin
-
15th January 2014, 09:31 PM #2
Gidday & welcome aboard Martin, may your journey with us be a pleasant one.
Regards Rumnut.
SimplyWoodwork
Qld. Australia.
-
15th January 2014, 09:55 PM #3
G'Day & Welcome to a top forum "Martin".
There are quite a few members on the Central Coast with heaps in the Greater Sydney & Newcastle areas......
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork..
Cheers crowie
PS - Best ask the specialist questions in the relevant forum sub-sections so you get a broader audience for answers....
-
16th January 2014, 01:14 AM #4
welcome aboard
-
16th January 2014, 08:19 AM #5
Retro Phrenologist
- Join Date
- Oct 2009
- Location
- Springfield NSW
- Age
- 71
- Posts
- 0
G'day Martin.
Welcome to the forum from just up the road in Springfield.
I can't help with the steaming, I have never tried it. Photos always go down well in this place -especially photos of work in process and setups to do thigs, like steam bending.____________________________________________________________
there are only 10 types of people in the world. Those that understand binary arithmetic and those that don't.
-
16th January 2014, 08:49 AM #6
Welcome to the forum.
I would suggest posting your questions in the General subsection of the forum the link I have pasted below.
WOODWORK - GENERAL
Not everyone looks into this section of the forum and you should get a few more replies. I might also suggest doing a search of the forum, try searching steam bending or another option would be to laminate thins strips of wood for the curved parts.
-
16th January 2014, 04:08 PM #7
GOLD MEMBER
- Join Date
- May 2013
- Location
- Rockhampton QLD
- Age
- 68
- Posts
- 1,570
Welcome to the forum Martin.
-
17th January 2014, 10:58 PM #8
Welcome to the forum Martin, enjoy !!
Cheers
Tony