![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 5 of 5
Thread: Old hand saw
-
8th July 2014, 11:32 AM #1
Senior Member
- Join Date
- Oct 2008
- Location
- Bouvard - Western Australia
- Posts
- 50
Old hand saw
This saw was bought new as a 22" & obviously well used by my ex-FIL's grandfather.
I have been told that this style of handle screw was last used in 1885. No makers name that I can see.
I was still using this until I retired a few years ago.
Col
2014-07-06 03.38.12.jpg2014-07-06 03.38.25.jpg2014-07-06 03.39.35.jpgChucks are like potato chips....you can't have just one.
www.bouvardbush.com
http://www.mandurahwoodturners.com/
-
8th July 2014, 01:21 PM #2
Well used for sure! Nice handle and would be good to find another blade for it.
Regards
John.
-
8th July 2014, 06:02 PM #3
The Saw.
Hi Col,
There must have been a reason for the curved cutting edge, or was it just sharpened that way. sure done a lot of work.
So will you clean it all up & hang it on your wall ???.
I reckon it might look pretty good, on a wall. Probably needs a good rest.
I'm assured that a Citrus Acid Bath will not hurt the Wooden Handle, but I haven't tried cleaning it that way.Regards,
issatree.
Have Lathe, Wood Travel.
-
8th July 2014, 06:26 PM #4
Yep, not much life left in that old beauty - it deserves an honorable retirement if ever a saw did!
John, might be easier to find a nice old saw to replace this one than finding another blade.....
Cheers,IW
-
9th July 2014, 10:37 PM #5
Col
Don't worry about another saw plate: Just give this one a couple more sharpenings and I think you could pass it off as a compass saw.
Yes, the split nuts fell from grace as soon as the modern style of sawnuts were patented in 1887. Those split nuts are fragile.
Your saw is interesting as it has no medallion, but that makes it very difficult to identify unless there are any markings on the saw plate itself. I would not be expecting an etch, but possibly some stamped marking. I am also guessing it is a panel saw as it only has three sawnuts. It also has a lambs tongue handle emphasising that it is a very early saw.
Regards
PaulBushmiller;
"Power tends to corrupt. Absolute power corrupts, absolutely!"