![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 4 of 4
-
21st September 2023, 10:20 AM #1
stacked leather handle for a hammer
This is a series of pics that I took while putting a new handle on an old hammer. The hammer is nothing special, just something I can throw into my tool box, so the finish and look are just as ordinary as you would expect for something like that. Interesting exercise though.
SAM_0241.JPG
the hammer
SAM_0242.JPG
The end of the grip/handle
SAM_0243.JPG
With the rubber grip removed you can see the shaft. I have recently replaced the stacked leather handle on a Cattaraugus knife so was inspired to do similar on this.
SAM_0244.JPG
1st job was an endcap/pommel. (thanks KB pensand more)
SAM_0245.JPG
Then cutting the leather and glueing it on with a clamp. I used kangaroo leather so it took a lot of pieces.
SAM_0246.JPG
More glueing, more clamping.
SAM_0247.JPG
Glueing and clamping finished and the end cap in place. I drilled a hole through the end cap and put a concrete mail to hold it all in place.
SAM_0248.JPG
Rough shaping with a bandsaw.
SAM_0249.JPG
Fine shaping with a belt sander, using the original as a guide.
SAM_0250.JPG
The finished article, nothing special but an interesting excercise.
-
23rd September 2023, 09:16 AM #2
Well done - does the leather need any treatment/dressing to preserve it?
I 'fixed' a small hammer that had a 'fibreglass' handle after someone (me) managed to break it doing something stupid. It is a very ordinary, cheap hammer but extremely useful for setting small tacks & pins so I wanted to resurrect it. In my case I drilled out the remnants of handle from the head & gave it a wooden handle. I'm certain my wooden handle is nicer to use than the original...
Cheers,
PS: I (almost) resisted the temptation to ask if it bounces around in the toolbox more than originally....IW
-
23rd September 2023, 12:39 PM #3
GOLD MEMBER
- Join Date
- Mar 2010
- Location
- US
- Posts
- 3,109
result looks great!
-
24th September 2023, 02:25 AM #4