Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: 3rd run ar a raised panel run
-
29th January 2015, 01:03 PM #1Senior Member
- Join Date
- Sep 2012
- Location
- ont Canada
- Posts
- 399
-
29th January 2015, 01:57 PM #2
Hi
Nice looking part...
Did you use a square or ball mill?
I fine the bigger the ball mill the better the finish... this depend on how tight the corners need to be and how many tool changes you wish to do.
Russsellvapourforge.com
-
4th February 2015, 11:32 AM #3Senior Member
- Join Date
- Sep 2012
- Location
- ont Canada
- Posts
- 399
bits
1/8 ball bit is good here in mdf and make a tight corner