Results 1 to 6 of 6
-
19th May 2024, 06:24 PM #1Senior Member
- Join Date
- Mar 2008
- Location
- Cairns
- Posts
- 229
how to fix this lock that was stuffed by someone? to make key fit
someone has tried to jemmy this lock with a screw driver stuffing it on the edge so now the key wont fit in it.
what can i use to remove this burr that has been created without damaging the lock??
-
19th May 2024, 08:09 PM #2Member
- Join Date
- Jun 2010
- Location
- SW Victoria
- Posts
- 92
I'd get the Dremel out, with a very small rasp bit
-
19th May 2024, 08:24 PM #3Senior Member
- Join Date
- Mar 2008
- Location
- Cairns
- Posts
- 229
-
19th May 2024, 08:44 PM #4Member
- Join Date
- Jun 2010
- Location
- SW Victoria
- Posts
- 92
Two great minds, none better mate
-
20th May 2024, 09:48 PM #5Senior Member
- Join Date
- Mar 2008
- Location
- Cairns
- Posts
- 229
done, ground the burr out a little bit and got a small screw driver to gently pry the remainder and the key managed to fit in there, used pliers to turn it as it was tight as the plate was bent, got it out, dismantled it all and hit the plates flat and reassembled and perfect again.
-
20th May 2024, 10:05 PM #6Member
- Join Date
- Jun 2010
- Location
- SW Victoria
- Posts
- 92
Similar Threads
-
replace old style privacy lock with entrance lock
By Reno RSS Feed in forum DOORS, WINDOWS, ARCHITRAVES & SKIRTS ETCReplies: 0Last Post: 17th June 2016, 02:50 PM -
Got a new HWS but I think I stuffed up!
By JohnJohns in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 12Last Post: 20th July 2007, 06:37 PM
Bookmarks