Results 1 to 1 of 1
-
23rd February 2009, 04:29 PM #1
Removing masonite & lino tiles from floorboards
Hi All,
I've seen a few topics about masonite removal involving staples however my situation differs, firstly, no staples.
I have baltic pine floorboards covered in a layer of masonite that has been nailed about every 10cm (over 20 metres squared that's a hell of a lot of nails).
Now the problem starts, on top of the masonite is 1 foot square lino tiles. I assume (by the uber bright lime green kitchen laminate bench) that this was all installed in the 70s and the tiles are slightly brittle now. Their adhesive however is not so its not possible (unless I had 2 years and lots of patience) to remove the lino first and then the masonite seperately.
I've removed a small section of only a couple of square metres and it took about three hours using a chisel (upside down). Slide under a little and slowly levering a small piece at a time, breaking it off and repeat, removing the nails aftwards.
It is getting it up ok, but baltic being quite soft the chisel is leaving marks. They are definitely no more than 1mm deep in any spot so I think once sanded it wont be an issue. However I was just wondering if anyone else has had this floor situatin and had any other method of pullling it all up without marking the bodrds at all.
Thanks,
Greg
Read the full thread at RenovateForum.com...
Similar Threads
-
Removing disintegrated lino goo
By lloyd in forum FLOORING, DECKING, STUMPS, etc.Replies: 6Last Post: 14th July 2005, 08:02 AM -
How do you remove old glue under lino tiles??
By georgw in forum TILINGReplies: 15Last Post: 9th September 2004, 10:01 PM
Bookmarks