Results 1 to 8 of 8
Thread: floating deck/pontoon
-
13th August 2005, 07:35 PM #1
floating deck/pontoon
I am fantasising about summer already, and we have hatched a plan to build a pontoon to moor to the side of our dam so you don't have to walk through the muddy edge when getting in and out of the water. Has anybody built one or seen a plan of one? We have some pickle barrels but I'm not sure if they will float too proud of the water and be unstable. Any suggestions gratefully received. Thanks, Helga
-
13th August 2005, 10:51 PM #2
How much weight will the pontoon have to bear?
To design the pontoon
1. calculate the volume of the pontoon (this lets you know how much water is displaced by the pontoon). For every 1000 cm3, the pontoon displaces 1 litre of water.
2. The displacement in litres = the weight the pontoon can take in kg. For safety, only load to 90%.
Example - say your barrel has a height of 80 cm and a diameter of 40cm (ie a radius of 20cm)
Volume of a cylinder = pi X radius squared X height
= 3.14 X 20 x 20 x 80 = 100,480cm3
Divide by 1000 to get litres = 100.48 litres
Therefore, your barrel could support a maximum of 100 kgs, although 90kg would be a safer limit."If something is really worth doing, it is worth doing badly." - GK Chesterton
-
14th August 2005, 12:18 AM #3Originally Posted by helgaWhatever note you blow youre never more than a semitone away from the correct one....(Miles Davis)
-
14th August 2005, 06:27 PM #4
Thanks for suggestions dion and kiwigeo.the pickle barrels we get held pickled onions and gherkins. I don't think I could eat my way through 1200L of gherkins. I'm feeling sick just thinking about it! Luckily we get them empty. I'm guessing 3 people and the timber for the deck of it would be the weight load. I will see what the demolition yard has in the way of ladders. I'm just not sure if I should tether it to the bank or anchor it to the dam floor or both!?helga
-
15th August 2005, 03:25 PM #5New Member
- Join Date
- Jun 2005
- Location
- -28.680409 / 153.360896
- Posts
- 4
helga,
what we did -
4x 200 L plastic drums from mountain chemicals in Lismore (ex detergent of some sort). They have 2 screw in bungs rather than lids.
Built a treated pine deck, over a frame that sits on the drums (lying on their side at each corner). Drums end up under the frame so you don't have to look at 4 big blue things... Frame was about third of the way down the drum so they don't go anywhere, but the frame stays clear of the water. Frame wasn't fixed to the drums, so if one gets a leak, drum just drops to the bottom of the dam.
Put drums in pond. Dropped deck and frame over drums. Sat 4 people on deck and loosened bungs to let water in until the whole thing sat at a nice height in the water. Worked around the 4 progressively to get it level. If you get it so that one bung is above water level, and one below, you can adjust the floating height by loosening bottom bung, then top bung - lets in water, close top bung and use a foot pump to pump air in bottom bung to raise etc
Attached floating deck to shore with a walkway long enough to deal with low dam level - galv gate hinges between deck and walkway, couple of those concrete house stump pads on shore with more galv hinges, so it adjusts to changes in water level.
Very popular with ducks and snakes.......
-r
-
16th August 2005, 01:53 PM #6Therapeutic woodworker
- Join Date
- Jun 2005
- Location
- rural Sydney
- Age
- 76
- Posts
- 5
Helga,
I did something like rhack but used a larger number of 20l plastic drums, the squareish type used for pool chlorine. They have a screw cap and a small bung where one can screw in a tap. I had them lying on their side under the treated pine decking and had the screw cap at the top and the small hole at the bottom with the bung out. Adjusted the floating depth by loosening the cap and letting air out as required etc. More fuss getting it even with a larger number of drums, but you only have to do it once. No need to plug the bottom hole - if the air can't get out the top then the water won't go in.
The partially filled drums give the pontoon a lot of stability. A pontoon with empty drums rides high and is very lively to walk around on.
Buy a good garden broom as you will need it for regular duck poo cleaning. Our snakes are much tidier and only red belly blacks, well the browns do visit but don't lie there sunning themseleves like the blacks.
cheersDr Dee
Trying to work less and machine my time away
-
17th August 2005, 09:12 AM #7
thanks guys
sounds like a lot of bunging about in the dam, will definitely have to wait for warmer weather, but at least now I know what parts to assemble. We also have yellow faced whip snakes, bandy bandy and carpet snake as well as red bellied blacks. I've only seen one brown here and it was a baby. I always think "where's mum?" when I see a baby snake.
-
22nd August 2005, 03:28 PM #8
If you want something that would best belong up the crick in the Beverly Hillbilly's then use the drums.
or
get a proffessional pontoon of the type used to moor small boats along side.
I used to help install these types of jetties for the mega rich in Sydney Harbour a few years ago using pacific marinas products. Dont know if they're still available but looked something like this only generally smaller
http://www.thejettyspecialist.com.au/domjet/index.html
The moving decking shown is steel with a timber top and the peiring is concrete where as we used turp piles and all jarah decking with gal pin hinges. Worked OK in Sydney during heavy winds/seas______________
Mark
They only call it a rort if they're not in on it
Similar Threads
-
Laminate Floating Floors
By jasonbrisbane in forum FLOORINGReplies: 2Last Post: 29th January 2005, 09:25 AM -
Floating floor, first time renovator!
By nine-to-fiver in forum FLOORINGReplies: 6Last Post: 13th August 2004, 07:30 PM -
floating timber floors in the kitchen
By Trav in forum FLOORINGReplies: 24Last Post: 15th June 2004, 11:20 AM
Bookmarks