Sicar Spindle Moulder

[ab1]

Hi,

I know most of the machines in this thread are a lot older but I thought is was my best bet.

I have just purchased a Sicar S1000M spindle moulder. It appears to have been made in 1987 according to the stamp on the plate on the back of the machine.

I was wondering, on the off chance, if someone may know where I could get a manual for it. Being that the machine is not that old, I figured it should be a lot easier than my other machines.

I have to replace the bearings and thought a manual may make it a bit easier.

Does Sicar have anything to do with SCM?? My searching on the net shows some similarity.

I have tried Gabbett Machinery but they were not helpful.. as usual.

Many thanks, Andrew.

[joez]

Might be worth shooting them an email and seeing if they can Email you a PDF or something: http://www.sicar.it/sic/

[djns]

Hi Andrew, I could send a PDF file in German if you like. As I am informed, Sicar closed in May 2013.

Kind regards djns

[ab1]

That would be great thanks. Any information would be greatly appreciated. I forgot about this thread. Have been so busy with work, I have not had a chance to look at it any further. I'll pm my email if that helps.