CNC made logo

[hughie]

OK some time back I had a letter stamp made up here and cannot remember who did it for me . Its was a brass name stamp for my wood turning with the name The Wooden Potter etc.

Now I need the services again for a slightly smaller stamp, again in brass as I heat it up to do the stamping. This one will a bit different as it be in part a logo as well as couple of letters. I can supply a pdf of the logo to give you some idea of what I'm after and we can take it from there.

[Smirkin]

If you want to find your old thread, just use the advanced search (top right of page) and use the key words - wooden potter.

[DJ’s Timber]

Maybe the original thread might refresh your memory

https://www.woodworkforums.com/showthread.php?t=166641

[skot]

Try Misan...they have a link on the Sponsor's Board

HERE'S a Start

[Greolt]

OK some time back I had a letter stamp made up here and cannot remember who did it for me . Its was a brass name stamp for my wood turning with the name The Wooden Potter etc.

Now I need the services again for a slightly smaller stamp, again in brass as I heat it up to do the stamping. This one will a bit different as it be in part a logo as well as couple of letters. I can supply a pdf of the logo to give you some idea of what I'm after and we can take it from there.

If it can be aluminium I will make it for you. If brass I only have 1/8" thick on hand. If it needs to be thicker then I would need to get some.

Send me the design.

Greolt

[Greolt]

I guess he doesn't need help with this now.

[bhavyamachine]

I think you should take a help of administrator...

[Bob Willson]

I think you should take a help of administrator...

Why?

[bhavyamachine]

May be he or she help to solve your problem?