![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 3 of 3
Thread: Gravity Fed HWS pump
-
4th November 2007, 11:48 AM #1
Gravity Fed HWS pump
Hello,
We have moved into a rented house that has mains pressure cold water with gravity fed hot water. Consequently the shower pressure is pathetic. I have asked the owner to install a mains pressure HWS but the tightar** wont do it. I dont mind spending a little bit of money to get better showers and wanted to know if it is a simple cheap job to install an inline hot water pump like these ones on ebay:
HW pump1
HW pump2
Any other ideas would be appreciated. I have looked at installing an electric hot water system off the mains pressure cold water but these units require upto 40 amp electrical outlets as well as plumbing. I am yet to try an oxygenating shower head, Ive bought one but waiting for it to arrive. Ive even looked at moving but it tooks us ages to find an house that will accept our dog so I don't really want to go through all that again.
Thanks
-
4th November 2007, 12:20 PM #2
Senior Member
- Join Date
- Jul 2007
- Location
- Sydney-south
- Posts
- 333
Not something Id like to do installing a pump in the ceiling, youd have to put a safetray under it and drain it to outside, then there may be an issue with noise transmission through your ceiling. Another way to do it would be to take the HW line outside to the pump then back in. A lot of hassle for a rental place. What type of shower head do you have? Try the standard shower arm with the round head, you can get them from bunnies or reece for around $15, pull the flow restrictor out of it and see how you go. If the landlord is a tight wad, check that he hasnt had flow restrictors installed in the tap bodies.
Plumbers were around long before Jesus was a carpenter
-
5th November 2007, 10:09 PM #3
Novice
- Join Date
- Sep 2006
- Location
- sydney
- Posts
- 23
Try the standard round universal showerhead without flow restrictor like WP said but then the next problem is trying to adjust the temperature because the cold is so much stronger. You can help this by installing an aqualoc water saving washer in the cold side to slow it down aqualoc.com.au , you have to experiment with different models to get it right though.
Similar Threads
-
Instant v stoarge Howt water service
By Mcblurter in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 48Last Post: 18th August 2007, 12:07 AM -
Sump pump setup
By Matt88s in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 3Last Post: 22nd April 2007, 03:01 PM -
Emptying gravity feed HWS ?
By nic in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 4Last Post: 8th April 2007, 08:39 AM -
Gravity fed shower - no good
By kayep in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 4Last Post: 31st May 2006, 12:52 AM -
Grundfos water pump
By Greyham in forum PLUMBING, ELECTRICAL, HEATING, COOLING, etcReplies: 3Last Post: 25th August 2005, 10:02 PM