Hi everyone,
I am in the process of doing a kitchen reno and have hit a stumbling block.
I want to knock down a short wall (build on another lintel and indirectly supporting other components that are hopefully going to be demolished- eg. oven walls) below a lintel supporting about three courses of bricks spanning about two metres. The lintel passes over this wall that I want to get rid of, and is "supported" by another full height internal wall. I had the walls checked by a builder and was told that they are ok to remove, but I have had second thoughts after finding that the lintel only overhangs the full height internal wall by about 9-10mm!!
I jumped onto the roof and checked it out from there and could see that there is another lintel coming off the other side of this internal wall (supporting a window) with even less overhang (6-7mm). Is this normal???
Most importantly, is there a way of having these two lintels "joined" so that the wall is actually supporting the lintels properly? and hopefully I can remove the short I hope this makes sense!
Thanks for your thoughts,
Mick.


Read the full thread at RenovateForum.com...