![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 3 of 3
-
11th September 2005, 01:07 PM #1
Senior Member
- Join Date
- Dec 2004
- Location
- Margaret River, Australia
- Posts
- 103
Steel Wool / Scouring Pads between coats of lacquer
I'm cheating by starting a new thread. But worried that the old one re SANDING between lacquer coats had run it's course.
So, on a slightly different topic...... is it possible with 2 pac acid curing lacquers to give a quick rub-back with a scouring pad or fine steel wool before re-coating? In my experience fine sanding (320 or higher) is so much more labour intensive than scouring or using steel wool. Particularly on "complicated" pieces with lots of edges. And trying to always go with the grain - I guess I'm seeking re-assurance from anyone who's familiar with 2 pac acid curing lacquers.
Thanks,
Richard
-
11th September 2005, 01:44 PM #2
Its not necessary to sand with the grain between coats, a quick light circular motion is fast and easy and will denib the finish quite well.
If you use steel wool be sure to use stainless steel wool as little bits of ordinary steel
wool get caught in the finish and can turn black spoiling an otherwise good finish
-
12th September 2005, 07:37 AM #3
Supermod
- Join Date
- Jul 1999
- Location
- Brisbane, Qld.
- Age
- 48
- Posts
- 579
You can use either or, But in my opinion sanding with abrasive paper is the better option by far, again it depends on the finish quality you want. But to confuse things, I use both. However, I only used steelwool / scouring pads on the turned sections and also the complex routed edges etc and also any square cornors.
As for sanding with the grain, Echidna is on the ball...However if your hand sanding it still is great practice to go with the grain especially if you are heavy handed. But if your using a high quality ROsander then its quick and painless with great results.
I actually find sanding AC lacquer rahter easy compared to some lacquers etc, but you need to get your mix acurate to help with the curing.
Similar Threads
-
Steel Wool
By COOPES in forum FINISHINGReplies: 6Last Post: 1st May 2012, 03:30 PM -
Spraying Lacquer
By Richardwoodhead in forum FINISHINGReplies: 35Last Post: 6th February 2006, 06:59 AM -
Sanding between coats of lacquer
By Richardwoodhead in forum FINISHINGReplies: 12Last Post: 9th September 2005, 02:23 PM -
When to use steel wool
By SteveI in forum FINISHINGReplies: 10Last Post: 25th May 2004, 08:03 PM -
0000 Steel Wool
By craigb in forum HINTS & TIPSReplies: 18Last Post: 16th May 2004, 10:59 PM