Results 1 to 7 of 7
Thread: Cleaning Silicone
-
26th October 2013, 06:58 PM #1GOLD MEMBER
- Join Date
- Dec 2010
- Location
- Mornington Peninsula
- Posts
- 408
Cleaning Silicone
I did a quick search and found nothing pertinent, although I am sure it has been mentioned previously.
I have silicone on the bathroom floor tiles and SWMBO is not impressed. I tried cleaning it with methylated spirits to no avail.
What can I use? Acetone perhaps? Any help would be appreciated.
-
26th October 2013, 07:22 PM #2
One of the quickest ways to turn silicone to jelly is attacking it with petrol, but I'm guessing turps will work as well.
-
26th October 2013, 10:34 PM #3
I bought "Silicon Remover" from Bunnings. Not sure what's in it but it worked. Turned the silicone to jelly which you scrape off. Took a few goes to get it all, but it got it in the end.
Cheers, Richard
"... work to a standard rather than a deadline ..." Ticky, forum member.
-
27th October 2013, 11:24 AM #4GOLD MEMBER
- Join Date
- Jun 2003
- Location
- Sunbury, Vic
- Age
- 85
- Posts
- 632
My first thought was Mineral Turps but perhaps you should check on the cartridge as they usually have some mention of clean up method.
Tom
"It's good enough" is low aim
-
27th October 2013, 11:51 AM #51/16"
- Join Date
- Mar 2007
- Location
- Adelaide South Australia
- Posts
- 76
silicone removal
I also used the bunnings product to clean up and separate class to a fish tank and altho it took time with several applications to penetrate the thicker sections it did work.
Don't force it, use a bigger hammer.
Timber is what you use. Wood is what you burn.
-
28th October 2013, 03:52 PM #6GOLD MEMBER
- Join Date
- Dec 2010
- Location
- Mornington Peninsula
- Posts
- 408
Just an update. I went to Bunnings and had a look at acetone and also the silicone cleaner, and thought that they may be a bit severe on the tiles. The last thing that I want is to make SWMBO unhappy by damaging the tiles.
So I tried petrol with good results, and also mineral turps. I washed over the area afterwards with methylated spirits to remove some of the oiliness and smell.
Whilst I still have some marks to come off, it appears to be that the best results are with petrol. Thought that this may help some.
-
12th November 2013, 10:56 AM #7Hewer of wood
- Join Date
- Jan 2002
- Location
- Melbourne, Aus.
- Age
- 71
- Posts
- 0
If you've got a bead say at a 90 degree join the easiest way to remove it IME is to undercut it with a razor blade and then peel it off.
Might work for smears on a tile if that was the problem too, but take care not to chip out the glaze.Cheers, Ern
Bookmarks