Results 1 to 4 of 4
  1. #1
    Join Date
    May 2012
    Location
    Sydney, Australia
    Posts
    2

    Default Novice Question - How to finish plywood for a built in desk

    Hi all,

    I am attempting to build a built in desk. I have 30mm BB HOOP PINE plywood that I will need to join (I have a biscuit joiner and believe I can handle this bit)

    I want to stain the plywood down toward a cedar - mahogany colour and then finish it with a durable top layer.

    I have done a lot of reading and feel like I know even less!

    I am confused about if I should use a "sanding sealer" (not sure if this is even the correct term) in order to make the stain application more consistant.

    Then what type of stain (eg water based? brand).

    Again the same for the top coats.

    Ideally if I could have suggestions around the most suitable products (and application method) that will work for a novice (I have varnished before etc, but was more luck than good judgement I'm sure)

    Thanks for your time
    Steve

  2. #2
    Join Date
    Jan 2012
    Location
    Melbourne
    Posts
    27

    Default

    Because hoop pine is so porous, it's best to prime it before sealing so the stain absorbs evenly. Feast watson timber primer makes a really stable base for staining.

    As for the stain, the truest colour you'll get is with a spirit based stain like Prooftint. To get the application right, mix prooftint with prooftint colour reducer which will give you more time to work it and make it really forgiving.

    I'd recommend getting some extra timber and testing your stain mix and application technique before you do your desk.

  3. #3
    Join Date
    Jun 2012
    Location
    Melbourne
    Posts
    4

    Default

    Do you have an orbital sander? If so, go over it with 180grit then 240, u can even go over with 320 just to get rid of the sanding marks. Ya need spirit based stain and a slow or medium drying thinners. 50/50 mix. Spray the stain not too heavy, i usually haze it with 2 coats. the trick is wait till the stain starting to dry, which is dulling off no massive wet or shiny spot then just rub it with clean rag then spray sealer on top 3 coats. Let that dry for an hour or so. Just Quickly run sander over it evenly then should be ready for top clear coat. Good luck

  4. #4
    Join Date
    May 2012
    Location
    Sydney, Australia
    Posts
    2

    Default

    Thanks all for your replies. Working on this now

Similar Threads

  1. Finishing a plywood desk top
    By Fast Eddy in forum FINISHING
    Replies: 5
    Last Post: 14th April 2011, 08:22 PM
  2. Novice floor tiling question(s)
    By adam01 in forum TILING
    Replies: 2
    Last Post: 27th October 2007, 02:27 PM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •