Results 1 to 2 of 2
  1. #1
    Join Date
    Feb 2012
    Location
    New Zealand
    Posts
    7

    Default Advice on sanding, and on masking stain

    Hi all,

    Two questions:

    1) Do I have to sand to the smoothest finish before I stain bare timber (birch ply) and then again afterwards, or just 'good enough' before the stain?

    2) If I mask areas of the timber with painters tape (and push it down really firmly along the edges) will stain bleed below the tape or will I get a nice straight line?

    Thanks!
    Peter

  2. #2
    Join Date
    Feb 2012
    Location
    New Zealand
    Posts
    7

    Default

    All right, I tried this on a scrap piece (of thin birch ply). I sanded it to a very smooth finish, then masked it with painters tape - pressing it down really tightly along the edge. I then rubbed the stain in (Wattle colourwood pigmented stain) with a cloth as per instructions. An hour later I removed the tape and the line was nice and straight with no bleed!

    So, at least this combination works ok with no bleeding: Birch ply + smooth sanding + painters tape + Wattle pigmented stain.

Similar Threads

  1. Replies: 0
    Last Post: 21st June 2010, 07:30 PM
  2. Sanding back out stain flecks...need help
    By kekemo in forum RESTORATION
    Replies: 0
    Last Post: 6th January 2009, 04:37 PM
  3. sanding sealer and stain
    By joseph84 in forum FINISHING
    Replies: 10
    Last Post: 31st August 2006, 07:00 PM
  4. Replies: 0
    Last Post: 5th September 2002, 10:43 AM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •