![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 3 of 3
Thread: Preserving the colour
-
2nd December 2012, 07:34 PM #1
New Member
- Join Date
- Dec 2012
- Location
- Australia
- Posts
- 1
Preserving the colour
I wonder if anyone has experience in preserving the bright colour of freshly cut Padauk. Before it oxidises it has remarkable almost orange colouring. (the sawdust it gets in everywhere. One needs an understanding wife)Apparently this colour will change in time to a brown. Does anyone know of a way of preserving that bright and very attractive colour. I am currently making a Marimba using Padauk and the colour is appropriate appropriate for the lively and fun type of instrument it is. Being an instrument it should not normally be exposed to rain and sun or too much abuse. Preserving the tone over time is also important. Would welcome some experience on this. Thanks
-
2nd December 2012, 08:03 PM #2
Welcome to the forums Out of Africa.
I had to do a little research on Marimbas. An impressive looking instrument. I am afraid I don't have specific information on Paduk, but in general timber colour is retained by oiling or varnishing. In the case of oiling, while it is a much more friendly treatment of timber it often requires frequent re-finishing. However that is normally no more than a wipe with fresh oil.
Most finishes enhance the colour but also slightly darken the colour at the same time. (Wiping your timber surface with a wet rag will simulate the colour you might expect.) I don't know if the overall colour will change.
I would be experimenting on some small sample pieces.
Regards
PaulBushmiller;
"Power tends to corrupt. Absolute power corrupts, absolutely!"
-
19th December 2012, 01:29 AM #3
SENIOR MEMBER
- Join Date
- Feb 2006
- Location
- melbourne
- Age
- 63
- Posts
- 0
Try feastwatson proof seal it has a UV inhibitor. No promises. Mick
Similar Threads
-
preserving timber joists
By mongrell in forum FLOORING, DECKING, STUMPS, etc.Replies: 3Last Post: 12th June 2007, 09:09 PM -
ongoing polishing / preserving
By Jedo_03 in forum FINISHINGReplies: 1Last Post: 2nd August 2006, 01:23 AM