![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
-
5th January 2009, 12:20 PM #1
Internal curved walling inside silo stairwell
Hi All,
I have a stairwell that is inside a curved wall cylinder. See attached picture. Basically it looks like a silo, and a spiral staircase goes inside. The studs are steel c-sectioned, standard steel wall studs.
Now i want to line the internal wall surface with plywood, 7mm stuff seems to curve fine. The 2 issues I have are
1. Fixing
2. Finished were the sheets but together
Fixing - I was thinking of gluing to the studs and screwing with ? Any suggestions for screw type? Countersunk would seem obvious , but I worried about them pulling all the way thru?
Finishing - where sheets of ply butt together, should I taper the edge first and then fill the joints with tape and bog like gyprock type sheets.
cheers
Mudguard
Attached Thumbnails
Read the full thread at RenovateForum.com...
Similar Threads
-
painting vaulted stairwell - scaffolding solution?
By baddog in forum PAINTING, PLASTERING, TILING, DECORATING, etc.Replies: 1Last Post: 22nd May 2007, 04:56 PM