![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 1 of 1
Thread: 260dgm worm
-
25th January 2023, 03:50 PM #1
Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,458
260dgm worm
Finally came up with a solution to the Hercus 260dgm apron feed shaft worm.
5h1805-s.jpg
The original had a short inbuilt key that was too hard to duplicate (at about $250 each part) so I went for a full length inserted key. As the original 9" and 260's had a key captivated by one pin, I thought two would be better.
Mal AMH
Attached Images
-
5h1805-s.jpg (215.8 KB)
Read the full thread at metalworkforums.com...