Results 1 to 4 of 4
  1. #1
    Join Date
    Nov 2008
    Location
    Hunter Valley
    Posts
    4

    Default Casting Resin? Blackbutt sap....help please

    Howdy all,

    This'll be my first foray into the "big time", I just myself some "real" timber not the veneers and floor boards I typically knock about. I'm making a simple hall stand.

    Anyhow, below is one of the boards, its Blackbutt. I really have no idea what to do with this. From what I have read I should be filling it with casting resin? can I tint that? if so what with?



    I guess I'd like it to look deep red, like the sap, and very shiny (like honey), but natural, when the finish is applied. Not sure if anyone has any ideas?

    Also, should I be filling the grain? can I use the casting resin for this? or should I just use timbermate as I normally do?

    Any help would be most appreciated.

    Cheers,
    Peter

    P.S. the only finish I know how to apply well is Shellac (well Hard Shellac, which I finish with EEE) so that's what I'll be using

  2. #2
    Join Date
    Jan 2010
    Location
    Melbourne
    Posts
    0

    Default

    I'd probably just leave it be however don't use Timbermate, it'd look awful. As you've suggested, casting resin would be the way to go. The Solid Cast 606, Clear Doming Epoxy should do the trick. Not cheap though.
    -Scott

  3. #3
    Join Date
    Nov 2008
    Location
    Hunter Valley
    Posts
    4

    Default

    Many thanks.

    So I'll fill the middle section with resin, what about the grain? should I just use resin for that as well? this is where I'd ordinarily use timber mate.


  4. #4
    Join Date
    Jan 2010
    Location
    Melbourne
    Posts
    0

    Default

    Fill the large voids with resin and leave the smaller cracks, I'd finish with a polyurethane finish. Sand from 80g, 120g, 180g, 240g, 320g and finally 400g then apply the finish, about 3-4 coats and sand with 400g in-between. You should get a nice finish and the polyurethane should fill those small cracks.
    -Scott

Similar Threads

  1. casting resin questions
    By Trav in forum FINISHING
    Replies: 28
    Last Post: 4th June 2005, 05:57 PM
  2. Clear casting resin.
    By Dennis Hill in forum FINISHING
    Replies: 4
    Last Post: 16th July 2000, 09:35 AM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •