![Thanks](https://www.renovateforums.com.au/dbtech/thanks/images/thanks.png)
![Likes](https://www.renovateforums.com.au/dbtech/thanks/images/likes.png)
![Needs Pictures](https://www.woodworkforums.com/images/smilies/happy/photo4.gif)
![Picture(s) thanks](https://www.ubeaut.biz/wave.gif)
Results 1 to 5 of 5
Thread: finishing ash
-
26th September 2003, 01:05 PM #1
Intermediate Member
- Join Date
- Sep 2003
- Location
- Weston, ACT
- Posts
- 6
finishing ash
Starting some desks and bookshelves using recycled quarter sawn ash. Has varnish or similar on it now, so have to get rid of that. The natural timber is pretty ordinary in terms of figure - basically there is none. Looks dry. Would like to darken it up a bit and get looking as good as possible though. Have read the thread on finishing tassie oak and wonder how much of what was said there could be applied to this stuff.
Would greatly appreciate any advice on offer.
-
26th September 2003, 03:35 PM #2
Haven't read that thread. Hopefully somewhere you can find the details from Shane or Neil on stripping old finishes.
I've had good luck of late with some similar 80+ year old bedside tables that were looking ordinary before sanding - looked like perfect firewood after sanding. After a shellac sanding sealer I tried some shellac on the underside of the top - still lifeless. I tried a cabots stain in 'golden maple' rubbed on with a rag - two coats did the trick. It gave a lot of life back to some pretty old looking timber. I might post some photo's of the results next week.
Good luck with it.
-
26th September 2003, 07:31 PM #3
Supermod
- Join Date
- Jul 1999
- Location
- Brisbane, Qld.
- Age
- 48
- Posts
- 579
you can basically apply any method to any type of timber, obviously results will vary greatly though.
-
30th September 2003, 03:29 PM #4
I agree with Eastie. get rid of the rubbish on there now, use a sanding sealer then a good quality stain - 1 or 2 coats depending on the colour that you want to achieve. Then 2 or more coats of a clear finish.
I prefer solvent based stains. Water based stains seem to still be a bit off the mark.Do or do not.....
Just try on a piece of scrap timber first.
-
30th September 2003, 11:50 PM #5
Intermediate Member
- Join Date
- Sep 2003
- Location
- Weston, ACT
- Posts
- 6
finishing ash
thank you all. If there's anything worth reporting as I try this and that I'll letcher know.