problem with spray gun finish

[Harry72]

You can leave the enamel in the pot Jill like wheelin said but you must still clean the gun out fully if leaving it for more than 20 minutes or so.

[Dengue]

thanks Harry, do you mean strip the gun down between coats, or just use another pot with thinners and squirt that through?

[Harry72]

Between coats on enamel(not that quick dry crap)should be a minimum of 12hrs so yes the gun will need cleaning, personaly I would clean the pot too because the paint on the side walls above the paint level will cure and will need stripper to remove it.

[wheelinround]

[wheelinround]

I sort of recall going over this 12 months ago with Garfield often good to do somethings again.